UTV Stereo UTVS-X3-HUMT-UP-UNIV Upper Display Mount Owner’s Manual
- June 9, 2024
- UTV Stereo
Table of Contents
UTV Stereo UTVS-X3-HUMT-UP-UNIV Upper Display Mount
INCLUDED PARTS LIST
THANK YOU FOR CHOOSING UTV STEREO PRODUCTS
Thank you for choosing UTV Stereo products. Your purchase of this UTV Stereo
product for use in your UTV indicates your desire for reliability and
performance audio that only comes from UTV Stereo.
UTV Stereo is your premier audio manufacturer. We offer the highest quality
products designed for your SXS. Stay one step ahead when you purchase UTV
Stereo products.
To take full advantage of the UTV Stereo X3 Universal Upper Display Mount,
please read and follow the instructions in this manual.
Designed for high performance audio systems, this mount is built rugged to
withstand the elements and has been designed specifically for use in SxS’s!
INSTALLATION
Professional installation by an authorized UTV STER EO dealer is highly recommended! Otherwise, the performance of your new gear may not be satisfactory. In the event that you decide to do your own installation, please read and follow this manual very carefully. Failure to do so may compromise the integrity of this product or your vehicle, and possibly void this product’s warranty.
INSTALLATION INSTRUCTIONS: UTVS-X3-HUMT-UP-UNIV
Steps
-
Using the specified mounting area, decide haw big your mounting hale needs ta be then use a hale saw ta make desired cutout into the middle af your mount.
-
Install your head unit into the cutout in the mount.
-
Remove brake reservoir caver ta gain access ta rear mounting dimples and remove the auxiliary pawer cutlet.
-
Ta run the wires from the head unit, remove the auxiliary pawer cutlet (Red Circle, Figure #1) then run wires through the hale. You may relocate your auxiliary pawer cutlet ta another location in the vehicle.
-
Line up the included plastic bracket with the front factory dimples an the dash (White Arrows, Figure #1).
-
Secure plastic bracket in place with E! af the included caurse thread screws and two washers.
The dimples are exactly where your screws should be drilled (White Arrows, Figure #1 & lb). -
Now that the Lower bracket is installed, place the upper display mount aver the installed plastic bracket. Use the E! machine screws ta secure the front of the upper display mount in place (Figure #2).
-
Use the remaining E! coarse thread screws and washers ta secure the back af the upper display mount ta the dash through the two rear dimples (Figure #3).
WARRANTY
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>