NETGEAR FA511 Fast Ethernet CardBus Notebook Adapter Installation Guide

NETGEAR FA511 Fast Ethernet CardBus Notebook Adapter

Start Here

Follow these instructions to install the FA511 Fast Ethernet CardBus Adapter in a notebook computer with the Windows Vista, Windows XP or Windows 2000 operating system with the latest service pack.

Package Contents

Verify that your package contains the following items:

• Model FA511 Fast Ethernet CardBus Notebook Adapter
• GearBox® for Adapters CD
• Installation Guide and Warranty Card

Install the FA511 Fast Ethernet CardBus Adapter

1. First, install the FA511 CardBus Adapter.
   The FA511 CardBus is hot-swappable which means that you can insert it into a PC that is either powered on or shut down.

   • a. Insert the FA511 CardBus Adapter into the CardBus slot on your notebook computer. Some PCs have more than one PCMCIA or CardBus slot; the FA511 can only be inserted into the CardBus Notebook adapter slot.
     Hold the PC Card with the NETGEAR logo facing up and insert it into the Card- Bus slot. Do not use excessive force, but make sure the card is fully inserted into the slot.

   • b. Insert the RJ-45 adapter cable into the connector on the outer edge of the network card.

   • c. Use a UTP cable to connect any port on a switch or hub to the FA511 Fast Ethernet CardBus Adapter.
     Note: One of the ports on NETGEAR hums is switchable between Normal (MDI-X) and Uplink (MDI) with a Normal/Uplink push button. If you are using this switchable port on a NETGEAR hub to connect to a PC or the network card, make sure the Normal/Uplink push button is set to Normal.
     Warning: Windows detects the Ethernet adapter, and automatically installs a driver based on its chipset. You must update that driver to work with the NETGEAR FA511 Fast Ethernet CardBus Adapter.

2. Then, install the FA511 network driver for your OS.
   To install the FA511 drive for Windows XP, 2000, Me or 98:
   Note: If the “Insert Disk” window opens and a message prompts you to insert your Windows CD-ROM, insert the CD and click “OK”. Then follow the next step in the instructions.

   • a. Insert the GearBox™ for Adapters CD into your CD-ROM drive. Windows will automatically detect the new FA511 CardBus Adapter hardware.

   • b. Follow the Found New Hardware Wizard steps.

   • c. Accept the Install the software automatically setting, and click Next to proceed.
     Note: If Windows XP or 2000 displays a Windows XP Logo Testing or a Digital Signature Not Found warning, click Continue Anyway or Yes to proceed.

   • d. Click Finish to complete the installation. If prompted to restart your computer, power down and restart the notebook.
     To install the FA511 driver for Windows Vista OS:

   • a. Insert the GearBox™ for Adapters CD into your CD-ROM drive.

   • b. From the Found New Hardware screen, select “Ask me again later”.

   • c. On the Found New Hardware—Ethernet Controller screen, select “I don’t have the disc. Show me other options.”

   • d. When the Windows couldn’t find driver software for your device message displays, select “Check for a solution.”

   • e. Then browse to the path where the fa511_vista\VISTA32 file is located and click Next. The Vista driver software will then be installed.

3. Now, configure the FA511.

   • a. Double-click the connection icon in the Windows system tray to open the Windows network connection page. If the connection icon is not visible, you can change the connection properties by going to Start > Control Panel > Network Connections.
   • b. Double-click on the FA511 Fast Ethernet CardBus Adapter connection.
   • c. Click Configure.
   • d. Click Properties and configure the FA511 according to your network requirements.
     For assistance with configuring the network settings, please see the networking tutorials on the NETGEAR Resource CD.

4. Finally, verify network connectivity.

   • a. From the Start menu, select Control Panel > System. The System Properties screen will display.
   • b. Select the Hardware tab, click Device Manager, and select Network adapters. A list of the available Network Adapters will be displayed.
   • c. Double-click the “NETGEAR FA511 CardBus Notebook Adapter.” A message screen will display describing the status of the device.
     Note: If there is a problem with the installation of the driver, an exclamation point will appear next to the “NETGEAR FA511 CardBus Notebook Adapter.” Try rebooting your computer or see the Troubleshooting section below.

Troubleshooting

If you have trouble setting up your FA511, check the tips below. You can also consult more extensive troubleshooting procedures on the NETGEAR, Inc. support website at http://kbserver.netgear.com/products/FA511.asp

powered on.

Remove and reinsert the FA511.

Check the Windows device manager to see if the FA511 Fast Ethernet CardBus Adapter is recognized and enabled.

Reload the FA511 software, if necessary.

The Link/Act LED light is lit, but the 100 LED is not lit.| The FA511 is operating at 10 Mbps.| The computer is connected to a router or other network device that is operating at 10 Mbps.

If you connect to a 100 Mbps device, the 100 LED will be green.

The 100 LED is blinking intermittently.| There is a problem with the link such as a speed mismatch, possible bad cable, bad connector, or configuration mismatch.| Check the network cable and make sure it is functioning properly.

Try plugging the network cable into a different port on the router attached to the Ethernet adapter.

Technical Support

Thank you for selecting NETGEAR products. After completing setup and configuration, locate the serial number on the bottom label of the FA511 Fast Ethernet CardBus Adapter and use it to register your product at http://www.netgear.com/register. Registration on the website or over the phone is required before you can use our telephone support service. The phone numbers for worldwide regional customer support centers are on the Warranty and Support Information card that came with your product.
Go to http://www.netgear.com/support for product updates and web support.

Trademarks
NETGEAR® is a registered trademark of NETGEAR, INC.Windows®is a registered trademark of Microsoft Corporation.Other brand and product names are trademarks or registered trademarks of their respective holders.Information is subject to change without notice. All rights reserved.

Statement of Conditions
In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves the right to make changes to the products described in this document without notice. NET-GEAR does not assume any liability that may occur due to the use or application of the product(s) or circuit layout(s) described herein.

Certificate of the Manufacturer/Importer
It is hereby certified that the Model FA511 CardBus Notebook Adapter has been suppressed in accordance with the conditions set out in the BMPT-AmtsblVfg 243/1991 and Vfg 46/1992. The operation of some equipment (for example, test transmitters) in accordance with the regulations may, however, be subject to certain restrictions. Please refer to the notes in the operating instructions. Federal Office for Telecommunications Approvals has been notified of the placing of this equipment on the market and has been granted the right to test the series for compliance with the regulations.

VCCI Statement

This equipment is in the Class B category (information equipment to be used in a residential area or an adjacent area thereto) and conforms to the standards set by the Voluntary Control Council for Interference by Data Processing Equipment and Electronic Office Machines aimed at preventing radio interference in such residential areas. When used near a radio or TV receiver, it may become the cause of radio interference. Read instructions for correct handling.

Federal Communications Commission (FCC) Compliance

Notice: Radio Frequency Notice
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1. Reorient or relocate the receiving antenna
2. Increase the separation between the equipment and the receiver
3. Connect the equipment to an outlet on a circuit different from that to which the receiver is connected
4. Consult the dealer or an experienced radio/TV technician for help.

EN 55 022 Statement
This is to certify that the Model FA511 CardBus Notebook Adapter is shielded against the generation of radio interference in accordance with the application of Council Directive 89/336/EEC, Arti-cle 4a. Conformity is declared by the application of EN 55 022 Class B (CISPR 22). Compliance is dependent upon the use of shielded data cables.

Canadian Department of Communications Radio Interference Regulations
This digital apparatus (Model FA511 CardBus Notebook Adapter) does not exceed the Class B limits for radio-noise emissions from digital apparatus as set out in the Radio Interference Regulations of the Canadian Department of Communications.

Disposal

This symbol was placed in accordance with the European Union Directive 2002/96 on the Waste Electrical and Electronic Equipment (the WEEE Directive). If disposed of within the European Union, this product should be treated and recycled in accordance with the laws of your jurisdiction implementing the WEEE Directive.

Trademarks
© 2007 by NETGEAR, Inc. All rights reserved. NETGEAR and the NETGEAR logo are registered trademarks of NETGEAR, Inc. in the United States and/or other countries. Other brand and product names are trademarks or registered trademarks of their respective holders. Information is subject to change without notice.

FAQ’s

What is the NETGEAR FA511 Fast Ethernet CardBus Notebook Adapter?

The NETGEAR FA511 is a Fast Ethernet CardBus notebook adapter designed to provide wired Ethernet connectivity to laptops and notebooks.

What are the key features of the NETGEAR FA511 Ethernet CardBus Adapter?

The NETGEAR FA511 typically features 10/100 Mbps Fast Ethernet support, CardBus interface, plug-and-play installation, and compatibility with various operating systems.

What type of Ethernet connection speed does the FA511 support?

The NETGEAR FA511 supports Fast Ethernet, which typically provides network speeds of 10/100 Mbps, making it suitable for both home and office use.

Is the NETGEAR FA511 CardBus Adapter compatible with older laptop models?

Yes, the CardBus interface used by the FA511 is compatible with older laptop models that have CardBus slots, allowing them to add Ethernet connectivity.

Does the FA511 require additional drivers or software for installation?

In many cases, the NETGEAR FA511 is designed for plug-and-play installation and does not require additional drivers or software for basic Ethernet connectivity.

What operating systems are typically supported by the FA511 CardBus Adapter?

The NETGEAR FA511 is often compatible with various operating systems, including Windows and some Linux distributions. Check the product documentation for specific OS compatibility.

Is the NETGEAR FA511 suitable for connecting to home or office networks?

Yes, this CardBus adapter is suitable for connecting laptops and notebooks to both home and office Ethernet networks for internet access and local network resources.

Can the FA511 adapter be used with older Ethernet hubs or switches?

Yes, the NETGEAR FA511 is typically compatible with older Ethernet hubs and switches that support 10/100 Mbps Fast Ethernet connections.

What is the warranty period for the NETGEAR FA511 CardBus Adapter?

The warranty terms for this adapter may vary, so it's advisable to check the warranty information provided by the manufacturer or retailer.

Is the FA511 CardBus Adapter suitable for mobile use with laptops?

Yes, this CardBus adapter is designed for mobile use and can be used with laptops and notebooks, providing wired Ethernet connectivity on the go.

Does the FA511 support full-duplex operation for faster data transfer?

Yes, the NETGEAR FA511 typically supports full-duplex operation, allowing for faster and more efficient data transfer on compatible networks.

Is there any security or encryption features included with the FA511 CardBus Adapter?

Security and encryption features are typically not included with this adapter, so additional network security measures may be required.

Is the FA511 CardBus Adapter suitable for connecting to broadband internet?

Yes, the NETGEAR FA511 can be used to connect laptops to broadband internet services via Ethernet, providing reliable internet access.

References:NETGEAR FA511 Fast Ethernet CardBus Notebook Adapter – Device.report

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>