BYTECH 2AHN6-AUBE227 True Wireless Earbuds User Manual
- June 13, 2024
- Bytech
Table of Contents
BYTECH 2AHN6-AUBE227 True Wireless Earbuds
Package Contents:
- XT-71 True Wireless Earbuds
- Charging Travel Case
- 8 Ear Cushions in 3 sizes (2 Small, 2 Large, 4 Medium)
- USB-A to USB-C Charging Cable
- Instruct io n Manua l
Specifications
- Bluetooth® Version: 5.3
- Working distance: 33 ft
- Charge Connector: USB-C
- Speaker Size: <D6mm
- Frequency Response: 20Hz-20KHz
- Sensitivity: 107 dB +3 dB
- Charging Voltage: 5V/1A
- Case Battery: 180 mAh
- Case Charge time: Up to 1.5 hrs
- Earbuds Bat tery : 2 x 30 mAh
- Earbuds Charge time: ±1 hr.
- Play Time: Up to 4 hrs per charge
- Distortion Rate: THD < 1%
Operation Guide
Getting Started
Before using this device, fully charge it. Charging instructions can be found on page 6. Open the charging case and take out the earbuds and place them in your ears. The earbuds will pair to each other automatically.
Pairing
- Go to B luetooth® Settings on your mobile
- Turn Bluetoot h® ON, on your devi
- On your Bluetooth® device, select “iHome XT-71” from the list of available
- The earbud indicator LEDs w ill flash blue to indicate they are
Using Siri or Google Assistant
On either earbud, press the control button three times, in quick successio
n, to activate your Al assistant.’The Al assistant on your device must be
activated prior to this operation.
Basic Functions
R i ght Earbud:
- Double tap the control surface to play or pause the audio
- Tap and hold to skip to the next audio
- Sing le tap to raise the volume
Left Earbud :
- Do ub le tap the control surface to play or pause the audio.
- Tap and hold to skip to the previous audio
- Sing le tap to lower the volum.
Phone calls:
When there is an incoming call, the unit will pause the playback and ring
to alert you of the call. Phone call functions work the same on either of the
earbuds.• To answer an incoming call, single tap the control button of either
earbud. To end a call, do ub le tap the co nt ro l surface. To reject an
incoming call, tap and hold the control surface.
Volume controls may not work during phone calls with some smartphone models.
Troubleshooting
Earbuds do not sync with each other:
- Place the earbuds in the case, then take out the earbuds, ensuring both earbuds are turned
- On each earbud, press and hold the control surface for 5 The earbud will turn off after the LED flashes purple 3 times.
- Replace the earbuds in the charging
- Repeat the Getting Started
Earbuds do not pair to devi c e :
- Turn the Earbud s OFF by press ing the control surface on each earbud until the LEDblinks red, and then turns
- Replace the earbuds in the case. Turn your device’s Bluet oot h® OFF and then back ON. Then repeat the pairing process
Charging
- Replace the earbuds in the case.
- Connect the USB-C charging cable to the charging port on the bot tom of the charge
- Plug the cable into a standard USB 5V/1A or higher power output.
- When you plug the case into a charger, the LED Indicator Light will begin blinking. This means it is being charged.
- The light s on the buds in the case glow steady red, indicating they are charging.
- The lights on the buds will go out when fully charged or the case is upplugged from the power source.
- The Indicator Light will stop blinking and just glow when the case is fully charged.
- When fully charged, promptly unplug the charge case from the power source.
If you want to charge the earbuds from the charge case internal battery, simply replace them in the case. They will begin charging from the built-in case battery
Warnings
- Do not use this unit for anything other than its intended
- Do not puncture , throw , drop , bend, or modify this product.
- Do not throw this product into fire or water.
- Do not short-curcuit the battery with any metal or metallic
- Do not expose this product to corrosive liquids such as salt
- Do not operate the unit if it has been wet or moist to prevent against electric shock and/or injury to yourself and damage to the
- Do not allow children to play with this product as it is not a toy, and may present a choking
- Avoid leaving your device in direct sunlight, such as on the dashboard, console, or seat of a vehicle.
- Do not leave your device, or use your device, in any area where the temperature is likely to drop below 32°F, or may exceed 140°F, such as inside a closed vehicle on a hot
- Repairs to electrical equipment should only be performed by a qualified electrician. Improper repairs may place the user at serious
- Protect your hearing by always listening at a safe level. Prolonged use at elevated volumes may affect your hearing capacity and could result in hearing
- Use the earbuds with this charging case
- To avoid damage to the charging case, please only use a USB 5V/1A or higher charger.
- In order to ensure the battery life, charge normally at least once a month.
FCC
FCC ID : 2AHN6-AUBE227
This device complies with Part 15 of the FCC Rules. Operat ion is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television recep tion , which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution : Any changes or modifications not expressly approved could void the user’s authority to operate the equipment.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Warranty
By tec h NY INC. warrants this product to be materially free from defects and workmanship to the original purchaser for a period of 12 months from the original purchase date. Bytech responsibilit y with regard to this limited warranty shall be limited solely to repair or replacement at its option, of any product which fails during normal consumer use. This warranty does not extend to damage or failure which result s from misuse, neglect, accident, alterat ion, abuse, improper installation or maintenance. At any time during the 12 months period following the purchase, the product fails due to defects in material or workmanship, return the defective product (with freight prepaid) with proof of purchase.
WWW.BYTECHINTL.COM
Bytech NY Inc 2585 West 13street Bro ok lyn NY 11223
(718) 449 -370 0
MADE INCHINA
©20 23 BYTECH NY INC.
All trademarks and copyright s are the property of the respective companies