Vtech Go Go Smart Wheels 4 In 1 Zig Zag Raceway Instruction Manual

: June 13, 2024
: vtech

Table of Contents

INTRODUCTION
INCLUDED IN THE PACKAGE
INSTRUCTIONS
LABEL APPLICATION
ASSEMBLY INSTRUCTIONS
PRODUCT FEATURES
ACTIVITIES
ACTIVITIES
MELODIES
SONG LYRICS
CARE & MAINTENANCE
TROUBLESHOOTING
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

**Vtech Go Go Smart Wheels 4 In 1 Zig Zag Raceway Instruction Manual

**

INTRODUCTION

Thank you for purchasing the VTech® Go! Go! Smart Wheels® 4-in-1 Zig-Zag Raceway™ track set.
Get racing with the Four different track configurations. Open upa world of racing and stunt play. Choose from Battle Raceway, Zig-Zag Track, Stunt Raceway and Super Ramp. Let’s go!

INCLUDED IN THE PACKAGE

One Smart Point® Stunt Car

A

B

C

D

**E

**

F

G

H

I

J

K

Label Sheet
Quick Start Guide

WARNING
All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties, cords and packaging screws are not part of this toy and should be discarded for your child’s safety.
NOTE
Please save this Instruction Manual as it contains important information.
Unlock the Packaging Locks

Turn the packaging locks counterclockwise several times.
Pull out the packaging locks and discard.

INSTRUCTIONS

Battery Removal And Installation Stunt Car

Make sure the unit is turned OFF.
Find the battery cover located on the bottom of the Stunt Car. Use a screwdriver to loosen the screw, and then open the battery cover.
Remove old batteries by pulling up on one end of each battery.
Install 2 new AAA (AM-4/LR03) batteries following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended).
Replace the battery cover and tighten the screw to secure.

WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.

IMPORTANT: BATTERY INFORMATION

Insert batteries with the correct polarity (+ and -).
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
Only batteries of the same or equivalent type as recommended are to be used.
Do not short-circuit the supply terminals.
Remove batteries during long periods of non-use.
Remove exhausted batteries from the toy.
Dispose of batteries safely. Do not dispose of batteries in fire.

RECHARGEABLE BATTERIES:

Remove rechargeable batteries (if removable) from the toy before charging.
Rechargeable batteries are only to be charged under adult supervision.
Do not charge non-rechargeable batteries.

LABEL APPLICATION

**Please stick the labels to the track set as shown below:

**

ASSEMBLY INSTRUCTIONS

With the Go! Go! Smart Wheels 4-in-1 Zig-Zag Raceway™, Adult assembly required. For your child’s safety, do not let them play with this toy until it is fully assembled.

Battle Raceway

Insert B into A as shown below. Make sure you hear a clicking sound to confirm the pieces are firmly connected.
Insert C and D into A.
Insert E into B.
Snap F onto C and D as shown below, then insert F into E. Once the above steps are completed, the main building is complete. Please note that it cannot be disassembled.
Lay the assembled pieces down as shown.
Insert G and J into I, then connect to E.
Connect H to K, then connect K to B.

Once you’ve completed the above steps, the Battle Raceway is ready to play.

Zig-Zag Track

Slide G into the second floor slot as shown below. Make sure you hear a slight pop sound to confirm G has been connected correctly.
Connect H and I as shown below. Then connect them to A.
Slide J into the first floor slot, and snap J onto I, B and D.
Slide K into the ground floor slot, and insert K into A.

Once you’ve completed the above steps, the Zig-Zag Track ready to play!

Stunt Raceway

Disassemble J, K, G, H and I. Slide G into the second floor.
Insert I into J, then slide J onto the first floor slot.
Connet K and J, then connect H with K.

Once you’ve completed the above steps, the Super Track is ready to play.

PRODUCT FEATURES

On/Off Switch To turn the unit On, slide the On/Off Switch to the On position. To turn the unit Off, slide the On/Off witch to the Off o position.
Automatic Shut-Off
To preserve battery life, the Go! Go! Smart Wheels® Stunt Car will automatically power down after approximately 60 seconds without input. The unit can be turned on again by pressing the light up button or the engine button, rolling the car quickly, or triggering a SmartPoint® location.

Note
This product is in Try-me mode in the packaging. After opening the package, turn the vehicle off and on again to proceed with normal play. If the unit repeatedly powers down while playing, please install a new set of batteries.

ACTIVITIES

Stunt Car

Slide the On/Off Switch to turn the Stunt Car On. You will hear a song, phrase and sounds. The windshield light will flash with the sounds.
Press the Windshield Button to hear fun sounds, songs, phrases and melodies. The light will flash with the sounds.
Press the Engine Button to hear additional fun sounds and phrases. Lights will flash with the sounds.
Push the Stunt Car quickly to hear fun sounds. If a melody is already playing, push the Stunt Car to add fun sounds on top of the melody. Lights will flash with the sounds.
For even more sounds, phrases and lights, drive the Stunt Car over the three SmartPoint® locations on the Go! Go! Smart Wheels® 4-in-1 Zig-Zag Raceway™ track set. The Stunt Car also interacts with other Go! Go! Smart Wheels® play sets (each sold separately).

ACTIVITIES

Place the Stunt Car or any SmartPoint® vehicle (each sold separately) on any of the three SmartPoint® locations to trigger fun sounds, songs or phrases.
Put the Stunt Car on the SmartPoint® starting line, thenrelease and watch it race to the bottom.
. Easily re-configure the track set among the Battle Raceway, Zig-Zag Track, Stunt Raceway and Super Ramp track set-ups.

MELODIES

Für Elise
Did You Ever See a Lassie?
For He’s a Jolly Good Fellow
Funiculi, Funicula
London Bridge
McNamara’s Band

SONG LYRICS

Song 1
Get ready for an amazing show, My engine can’t wait to roar. Ready to jump and good to go Three, two, one, this is amazing!
Song 2
Here we go loopy loop, Here we go spinny spin, Here we go ’round the track I know that I’m going to win!
Song 3
Go! Go! Smart Wheels! I’m a Go! Go! Smart Wheels Stunt Car. Bouncin’ ’round the track. (Go! Go!) I can jump and drift and spin. Let’s Go! Go! and see! (Go! Go!)
Song 4
One, two, three, four, You know you can do so much more!

CARE & MAINTENANCE

Keep the unit clean by wiping it with a slightly damp cloth.
Keep the unit out of direct sunlight and away from any direct heat sources.
Remove the batteries if the unit will not be in use for an extended period of time.
Do not drop the unit on hard surfaces and do not expose the unit to moisture or water.

TROUBLESHOOTING

If for some reason the unit stops working or malfunctions, please follow these steps:

Turn the unit Off.
Interrupt the power supply by removing the batteries.
Let the unit stand for a few minutes, then replace the batteries.
Turn the unit On. The unit should now be ready to use again.
If the unit still does not work, install a new set of batteries.

MPORTANT NOTE:
If the problem persists, please call our Consumer Services Department at 1-800-521-2010 in the U.S., 1-877-352-8697 in Canada, or by going to our website vtechkids.com and filling out our Contact Us form located under the Customer Support link. Creating and developing VTech products is accompanied by a responsibility that we take very seriously. We make every effort to ensure the accuracy of the information, which forms the value of our products. However, errors sometimes can occur. It is important for you to know that we stand behind our products and encourage you to contact us with any problems and/or suggestions you might have. A service representative will be happy to help you.

CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against 11115555 harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help

Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information

Trade Name: VTech®
Model: 5565
Product Name: Go! Go! Smart Wheels® 4-in-1 Zig-Zag Raceway™
Responsible Party: VTech Electronics North America, L.L.C.
Address: 1156 W. Shure Drive, Suite 200 Arlington Heights, IL 60004
Website: vtechkids.com

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
CAN ICES-003(B)/NMB-003(B)

Visit our website for more information about our products, downloads, resources and more.

vtechkids.com
vtechkids.ca
Read our complete warranty policy online at
vtechkids.com/warranty
vtechkids.ca/warranty
TM & © 2022 VTech Holdings Limited.
All rights reserved.
IM-556500-005
Version: 0