fri-jado BS10i BSi Euro Oven User Guide
- June 13, 2024
- fri-jado
Table of Contents
fri-jado BS10i BSi Euro Oven User Guide
Service instruction
Conversion to new generation Power &I/O board in the BSi
The below 9192202s board is no longer deliverable. This because some components became obsolete
The below 9192400 board will replace it
Old boards have spade terminals
“X” numbers to “J “ numbers
New boards have multi pole sockets
The kit comes with:
- An interface board 9192402 to convert the output wiring.
- A bracket with wiring to convert the input wiring.
- Mounting material.
The principle
Inputs are signals like switches and sensors. Outputs are power consumers like contactors, motors, lamps.
Old Old board connections.
New board with conversion
Preparation
Note that the assembly of boards has one spacer mounted, with the top,
cut off. Check if the connectors are completely pushed into each other.
Check if the “J” numbers on the plugs, correspond with the laser burned ones.
Conversion of the BSi
- Disconnect the mains power.
- Remove the service panel.
- Unscrew the screw and turn the I/O board outwards.
- Disconnect all wires and number them with the “X” numbers.
- Connect the mains power and upgrade the software, if applicable.
- Check all inputs and outputs by means of the I/O test facility in the service parameters.
- If everything ok, then remount the side panel.
Overview of board terminals
Leave this sheet in the oven, next to the electric diagrams for future trouble
shooting.
Electrical diagram of the new board assembly.
Service kit 9192205s. BSi form 9128153 rev.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>