Hanwha Vision SBC-165W TID-600R Intercom Network Video Door Station User Guide

Table of Contents

Hanwha Vision-SBC-165W-TID-600R-Intercom-Network-Video-Door-Station-
product

Product Information

The product consists of the following components:

Skin Cover (SBC-165W): A cover that can be used to change the color of the TID-600R Intercom to white.
Tilt Mount (SBS-165TM): A mount used to install the TID-600R Intercom on a wall at a tilted angle.
Flush Mount (SHS-165F): A mount used to install the TID-600R Intercom camera in a buried type.

Product Usage Instructions

Installation of Skin Cover (SBC-165W)

Install the skin cover by placing it over the front of the Intercom, covering it completely.
To remove the skin cover, unscrew the screw at the bottom of the Intercom and separate the Intercom’s main body from the mount plate. Then, spread the skin cover to both ends and separate it.

Installation of Tilt Mount (SBS-165TM)

First, attach the Intercom’s mount plate to the tilt mount on the wall.
Connect the mount plate to the Intercom’s main body.
Before installing the tilt mount on the wall, consider the direction in which the Intercom’s front side will face. The up and down orientation of the tilt mount changes based on the installation direction. Check the arrow indicator on the side of the tilt mount that corresponds to the wall.

Installation of Flush Mount (SHS-165F)

Attach the Intercom to the flush mount.
Install the flush mount on the wall.
Before attaching the Intercom, confirm the up and down orientation of the flush mount.
To remove the flush mount cover, separate it by pulling the area of a gap on both sides while pressing the front part.

Package (SBC-165W)

Package (SBS-165TM)
Package (SHS-165F)

Hanwha Vision-SBC-165W-TID-600R-Intercom-Network-Video-Door-Station-
fig.3

SBC-165W is a skin cover with which the color of TID-600R Intercom can be changed to white.
SBS-165TM is a mount for installing the TID-600R Intercom on a wall at the tilted angle of 30°.
SHS-165F is a mount for installing the TID-600R Intercom camera in a buried type

Install the skin cover from the Intercom’s front as if covering it.
To remove the installed skin cover, take off the screw at the bottom of the Intercom and separate the Intercom’s main body from the mount plate.
3 As shown in the figure, separate it while spreading the skin cover to both ends.

Installation (SBS-165TM)

First, attach the Intercom’s mount plate to the tilt mount on the wall, then connect it to the Intercom’s main body.
Before installing the tilt mount on the wall, it is necessary to consider which direction the Intercom’s front side will face. As shown in the figure below, the up and down of the tilt mount changes as per the installation direction. Check the arrow indicator of a wall on the side of the tilt mount.

Installation (SHS-165F)

After attaching the Intercom to the flush mount, install it on the wall.
- Before attaching the Intercom, confirm the up and down of the flush mount.
When the installation of flush mount on the wall is completed, attach the flush mount cover.
To take off the flush mount cover, separate it by pulling the area of a gap on both sides while pressing the front part as shown in the picture.