INVACARE H112-5 Bath Board User Manual
- June 4, 2024
- INVACARE
Table of Contents
INVACARE H112-5 Bath Board
General
Symbols
Signal words are used in this manual and apply to hazards or unsafe practices
which could result in personal injury or property damage. See the information
below for definitions of the signal words.
WARNING: Warning indicates a potentially hazardous situation which, if
not avoided, could result in death or serious injury.
CAUTION: Caution indicates a potentially hazardous situation which, if
not avoided, may result in property damage or minor injury or both.
This product complies with Directive 93/42/EEC concerning medical devices.
Life
The expected service life of the product is one year when used in accordance
with the safety instructions, maintenance intervals and correct use, stated in
this manual. Effective service life can vary according to frequency and
intensity of use. Maintenance and inspection should be done at least every six
months.
Weight Limitation
The weight limitation of this product is 330 lbs (150 kg).
Product Labeling and Product Specification s
Safety
Intended Use
The bath board is intended to be used inside the bathtub. All other use can
cause risk of injury.
General Warnings
WARNING: DO NOT USE THIS PRODUCT OR ANY AVAILABLE OPTIONAL EQUIPMENT WITHOUT FIRST COMPLETELY READING AND UNDERSTANDING THESE INSTRUCTIONS AND ANY ADDITIONAL INSTRUCTIONAL MATERIAL SUCH AS OWNER’S MANUALS, SERVICE MANUALS OR INSTRUCTION SHEETS SUPPLIED WITH THIS PRODUCT OR OPTIONAL EQUIPMENT. IF YOU ARE UNABLE TO UNDERSTAND THE WARNINGS, CAUTIONS OR INSTRUCTIONS, CONTACT A HEALTHCARE PROFESSIONAL, DEALER OR TECHNICAL PERSONNEL BEFORE ATTEMPTING TO USE THIS EQUIPMENT – OTHERWISE, INJURY OR DAMAGE MAY OCCUR.
ACCESSORIES WARNING
Invacare products are specifically designed and manufactured for use in
conjunction with Invacare accessories. Accessories designed by other
manufacturers have not been tested by Invacare and are not recommended for use
with Invacare products.
WARNING
Users with limited physical capabilities should be supervised or assisted
when using this product. Always test to see that the bath board is properly
and securely locked in place on the bath tub before using. Ensure all hardware
is tight at all times.
Usage
Installing the Bath Board
WARNING:
The bath board MUST BE installed properly.
ALWAYS install the bath board at least .78 in (2 cm) away from tub fixtures. At least .78 in (2 cm) of the bath board MUST hang over the outside of the tub.
- Maximum Tub Wall Thickness: .78 in (20 mm)
- Maximum Tub Width: 24.8 in (630 mm)
- Minimum Tub Width: 15.5 in (395 mm)
DO NOT use the bath board with tubs that have no inner wall.
- Place the bath board (A) onto a hard, flat surface.
- Align the handle (B) with the proper mounting hole in the bath board.
- Press the bath board handle into the mounting holes (C).
- Ensure the handle latches securely into the bath board.
- Ensure the handle cannot be pulled out of the bath board after installation
- Twist the mounting pin (D) clockwise to remove from the mounting peg (E).
- Position the mounting pin into the opening in the slot (F).
- Position the mounting peg under the bath board and onto the mounting pin.
- Twist the mounting peg clockwise to secure it to the mounting pin.
- Repeat STEPS 4 to 7 for the remaining three mounting pegs.
- Turn the bath board over.
- Twist each mounting peg counterclockwise to loosen.
- Slide the mounting pegs towards the middle of the bath board.
- Turn the bath board over.
- Position the bath board in the tub.
- Slide the mounting pegs towards the ends of the bath board.
- Turn the mounting pegs counterclockwise to secure the bath board in the tub. Torque to 53 in-lb (6 Nm).
- Insert plugs (G) into the openings in the slots.
Using the Bath Board
WARNING:
DO NOT slide the bathboard while using it.
DO NOT use the bath board if damage is found. Always test to see that the bath board is properly and securely locked in place on the tub before using.
Care and Maintenance
Cleaning the Bath Board
CAUTION: Risk of Product Damage.
Regular cleaning and inspection is recommended. DO NOT use an abrasive detergent, cleaner or cloth to clean or dry the bath board.
Clean the bath board by hand.
Maximum cleaning temperature is 176°F (80°C).
Limited Warranty – North America
PLEASE NOTE: THE WARRANTY BELOW HAS BEEN DRAFTED TO COMPLY WITH FEDERAL LAW
APPLICABLE TO PRODUCTS MANUFACTURED AFTER JULY 4, 1975.
This warranty is extended only to the original purchaser/user of our products.
This warranty gives you specific legal rights and you may also have other
legal rights which vary from state to state. Invacare warrants this product to
be free from defects in materials and workmanship for three years for the
original purchaser. If within such warranty period any such product shall be
proven to be defective, such product shall be repaired or replaced, at
Invacare’s option. This warranty does not include any labor or shipping
charges incurred in replacement part installation or repair of any such
product. Invacare’s sole obligation and your exclusive remedy under this
warranty shall be limited to such repair and/or replacement. For warranty
service, please contact the dealer from whom you purchased your Invacare
product. In the event you do not receive satisfactory warranty service, please
write directly to Invacare at the address on the back cover. Provide dealer’s
name, address, model number, the date of purchase, indicate nature of the
defect and, if the product is serialized, indicate the serial number. Invacare
Corporation will issue a return authorization. The defective unit or parts
must be returned for warranty inspection using the serial number, when
applicable, as identification within thirty (30) days of return authorization
date. DO NOT return products to our factory without our prior consent. C.O.D.
shipments will be refused; please prepay shipping charges.
LIMITATIONS AND EXCLUSIONS: THE WARRANTY SHALL NOT APPLY TO PROBLEMS ARISING
FROM NORMAL WEAR OR FAILURE TO ADHERE TO THE ENCLOSED INSTRUCTIONS. IN
ADDITION, THE FOREGOING WARRANTY SHALL NOT APPLY TO SERIAL NUMBERED PRODUCTS
IF THE SERIAL NUMBER HAS BEEN REMOVED OR DEFACED; PRODUCTS SUBJECTED TO
NEGLIGENCE, ACCIDENT, IMPROPER OPERATION, MAINTENANCE OR STORAGE; OR PRODUCTS
MODIFIED WITHOUT INVACARE’S EXPRESS WRITTEN CONSENT INCLUDING, BUT NOT LIMITED
TO: MODIFICATION THROUGH THE USE OF UNAUTHORIZED PARTS OR ATTACHMENTS:
PRODUCTS DAMAGED BY REASON OF REPAIRS MADE TO ANY COMPONENT WITHOUT THE
SPECIFIC CONSENT OF INVACARE; PRODUCTS DAMAGED BY CIRCUMSTANCES BEYOND
INVACARE’S CONTROL; PRODUCTS REPAIRED BY ANYONE OTHER THAN AN INVACARE DEALER,
SUCH EVALUATION SHALL BE SOLELY DETERMINED BY INVACARE. THE FOREGOING WARRANTY
IS EXCLUSIVE AND IN LIEU OF ALL OTHER EXPRESS WARRANTIES, IF ANY, INCLUDING
THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE. IT SHALL NOT EXTEND BEYOND THE DURATION OF THE EXPRESSED WARRANTY
PROVIDED HEREIN AND THE REMEDY FOR VIOLATIONS OF ANY IMPLIED WARRANTY SHALL BE
LIMITED TO REPAIR OR REPLACEMENT OF THE DEFECTIVE PRODUCT PURSUANT TO THE
TERMS CONTAINED HEREIN. INVACARE SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL OR
INCIDENTAL DAMAGES WHATSOEVER. THIS WARRANTY SHALL BE EXTENDED TO COMPLY WITH
STATE/PROVINCIAL LAWS AND REQUIREMENTS.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>