InCartec 29-CT-801 Vauxhall-Opel Steering Wheel Control Interface Installation Guide
- June 13, 2024
- InCarTec
Table of Contents
InCartec 29-CT-801 Vauxhall-Opel Steering Wheel Control Interface
INSTRUCTION
The information provided in this document is subject to change without notice due to changes and/or improvements to the product/s.
Vehicle Application
- Vauxhall Antara 2006 – 2010
- Vauxhall Astra (H) 2004 – 2010
- Vauxhall Corsa (C/D) 2004 – 2009
- Vauxhall Meriva (A, X01) 2005 – 2010
- Vauxhall Signum 2005 – 2008
- Vauxhall Tigra 2004 – 2009
- Vauxhall Vectra (C, Z02) 2004 – 2008
- Vauxhall Zafira (B) 2005 – 2014
Key Features
- Retains Steering Wheel Controls
- Retains System Settings Menu via SWC
- Provides Speed Pulse, Park Brake, Reverse Gear, Telephone Mute
Outputs
ABOUT THIS PRODUCT
29-CT-801
CAN-Bus Steering Wheel Control Interface for Vauxhall/Opel vehicles with
CD30/CDC40/CD50/CD70 original stereo and Quadlock connector.
WIRING COLOUR CODES
- Purple Right Rear Speaker +
- Purple/Black Right Rear Speaker –
- Green Left Rear Speaker +
- Green/Black Left Rear Speaker –
- Grey Right Front Speaker +
- Grey/Black Right Front Speaker –
- White Left Front Speaker +
- White/Blac k Left Front Speaker –
- Yellow Permanent 12V
- Black Ground
- Red Ignition 12V
- Orange Illumination
- Pink Speed Pulse
- Green Park Brake
- Purple/Whit e Reverse Gear
- Yellow/Black Telephone Mute
PRIOR TO INSTALLATION
Read the manual prior to installation. Technical knowledge is necessary for installation. The place of installation must be free of moisture and away from heat sources. Please ensure that the correct tools are using during the installation to avoid damage to the vehicle or product.
FITTING GUIDE
-
Remove and disconnect the original head unit.
-
Connect the 12 way molex connector of the head unit patch lead (supplied separately) to the interface.
-
Connect the opposite end of head unit patch lead to the head unit steering
wheel control input on the back of the aftermarket head unit.
NB: This may be a 3.5mm jack plug or a wire input depending upon the head unit brand being fitted. Please see the head unit installation manual for further information on where to connect.
Important: This step must be completed before connecting power to the interface. Failure to so do may result in no steering wheel control function. -
Connect the 14 way molex connector to the interface
-
Connect the male power/speaker ISO harness to the female power/speaker ISO har-ness from the aftermarket head unit. For aftermarket head units without an ISO connector, please refer to “Wiring Colour Codes” on Pg. 2.
-
Connect the female vehicle specific connector on the harness to the male vehicle connector from the vehicle. Test head unit for correct operation.
STEERING WHEEL CONTROL FUNCTIONALITY
ACCESSING SYSTEM SETTINGS
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>