InCarTec 27-274 Camera Interface User Manual
- October 30, 2023
- InCarTec
Table of Contents
27-272 – RETAIN ORIGINAL CAMERA ON TOYOTA AYGO,
PEUGEOT 108, CITROEN C1 (2014-2022)
27-274 Camera Interface
Retention camera
interface allowing you to retain/ keep the factory OEM fitted reverse view
camera on Toyota Aygo, Peugeot 108 and Citroen C1 (2014 – 2022 cars, when
replacing with a new aftermarket head unit. This interface is compatible with
the camera on original X-Touch and X-Nav radios with an 8 Pin connector.
INSTALLATION DIAGRAM
PLEASE NOTE: The diagram below shows an overview for the installation of this
product. Please turn over the page for step by step instructions.
PLEASE NOTE:
The following diagrams show how to connect the camera interface in conjunction
with our 29-707 steering wheel control interface. The 29-707 interface also
provides a reverse output to switch the radio to the camera feed when the car
is put in reverse.
THESE ARE SOLD SEPERATELY PLEASE REFER TO THE MANUFCTURERS INSTRUCTIONS ON HOW
TO CONNECT THE STEERING CONTROL INTERFACE.
NSTALLING WITH AFTERMARKET SWC INTERFACE
- Disconnect the original OEM radio from the car. Make a note of the connections highlighted (Left Image)
- Set up your aftermarket head unit as per the manufacturers instructions
- Plug in the car specific Steering wheel interface as per the manufacturers instructions.
NOTE: Make sure you leave the Black ISO connector from the steering wheel
control interface unplugged, this is used in the next step of the
installation.
The installation should be starting to look a little something like this
STEP 4
Connect the black ISO from the steering wheel interface (A) to the female ISO
connector on the camera interface (B)
Then
Connect the Male ISO connector of the camera interface (C) to the wiring loom
of the aftermarket head unit (D)
STEP 5
Connect the male RCA Plug of the camera interface to the camera input of the
aftermarket head unit. This is usually a Brown Female RCA connection on the
back of the unit but can vary depending on the manufacturer.
NOTE: Refer to the manufacturers instructions to confirm camera input
connection. STEP 6
Connect the loose reverse wire (Usually a Purple/White wire) leading out from
the aftermarket radio wiring harness, to the dedicated reverse light supply.
This is usually found at the rear/ reversing lights.
NOTE: These colours can vary depending on the make of head unit. Please
refer to the manufacturers instructions.If there is no dedicated reverse feed
from the original unit then you will need to use the dedicated 12v reverse
light supply. This is found at the rear/ reversing lights
STEP 7
Make the necessary connections to the wires leading out from the original
radio. These are all shown in the diagram on the right.
NOTE: The OEM connectors should look similar to the ones shown on the back of
the OEM radio in step 1 STEP 8
Go into the menu settings on the aftermarket head unit to activate/ turn on
camera.
NOTE: Picture is for demonstration purposes only and varies depending on the
head unit you are installing. Refer to the manufacturers nstructions on
how
to do this.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>