Xline Beam XLB252WB Xline Luminaire Beam User Guide
- June 13, 2024
- Xline Beam
Table of Contents
Xline Beam XLB252WB Xline Luminaire Beam
Dimension
XLB252WB | 1220 mm | White / Black | 25W | 3000K | 3 x 1000 lm | CRI 90 |
---|---|---|---|---|---|---|
XLB252BB | 1220 mm | Black / Black | 25W | 3000K | 3 x 1000 lm | CRI 90 |
incl. 1 x LED Driver 700 mA DALI Dimmable
Safety
For indoor use only.
This fitting should only be installed in rooms where direct contact with water
is impossible.
Luminaire not suitable for covering with insulating material.
Protected against objects ≥ 12,5 mm. Not protected against water.
Correct disposal of this product (electrical & electronical equipment waste)
This product contains a light source of energy efficiency class E
Installation Montage
Installation
Please follow the sequence of installation step by step:
- Switch off the electricity before commencing installation or lamp change
- Cut the correct sized hole in the ceiling in the required location
- FIRST: The luminaire MUST be connected to a driver and not directly to the mains electricity supply
- SECOND: Connect primary side of driver to power supply (230 V)
- Put the driver in the recess hole
- Press both springs of the luminaire upwards and place it into the cut-out
Warning
WARNING!
To prevent electrical shock – Always switch off electricity supply before
installation and maintenance.
The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. Improper installation can result in serious injuries and/or damage to property.
For safety and guarantee reasons it is prohibited to make any modifications to the unit.
Instructions Surface Mounted Installation
Instructions Suspended Installation
Customer Support
Belcrownlaan 13-Q – 2100 Antwerpen Belgium – T+32(0)3 6416140 – www.unibright.be
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>