Gelius Primor 230 Home for Marbled Ripado TV Instruction Manual
- June 13, 2024
- Gelius
Table of Contents
Gelius Primor 230 Home for Marbled Ripado TV
Product Information
- Product Name: PRIMOR 230
- Product Type: Panel
- Dimensions: 2500mm x 246mm x 2290mm
Assembly instructions
Recommendations
This product must be assembled by a professional.
Prepare the room before starting the assembly, leaving it completely clean and
the area in good condition to start the work. Use the cardboard of the
packaging to separate and support the parts removed from the boxes.
How to use the Minifig Set (when used in the product).
Apply glues to the wooden dowels (when used in the product).
Recommended tools
Hardware
Assembly
Use glue on the wooden dowel
O 10 al panel de lamas. The shim nº 10 must not be applied to the slatted panel.
Use glue on the part 02
Use glue on the part 02
ATTENTION
Before starting the installation, check all the conditions of the wall,
notably regarding resistance and weight support and the existence and position
of hydraulic, gas and electrical lines, avoiding damage to these structures
when running holes. not responsible for problems caused by inexperience, or
failure to follow due recommendations in the assembly and installation of
their products by third parties.
Define the location and height at which the panel is to be installed and mark the position of the fixing holes on the wall.
ATTENTION
When marking the position of the holes in the wall, make sure that the panel
will be leveled. With drilling machine and drill (not supplied with the
product), make the holes in the wall.
Use the Gauge Ruler.
Panel. Set the height at which the Panel will be installed.
Fit the panels to the rulers n°04 and 11 in the sequence as shown in the drawing.
Tip
In this step, pass all the necessary wiring, including the led strip.
Finish assembling the panels.
Attention
Use the measurements informed to correctly fix the accessories
Measures with the shelf on top.
Measures with the shelf at the bottom.
KIT LED
*
If the shelf is installed at the bottom of the panel, fix the angle bracket
under the shelf.
