Gelius HT-12 10W LED Lamp Wireless Charger User Manual
- June 6, 2024
- Gelius
Table of Contents
HT-12 10W LED Lamp Wireless Charger
User Manual
Product Introduction
Thanks for purchasing our product quick charge LED lamp wireless charger. It
adopts a high-end quick charge IC with its luxury and compact design, it can
be compatible with any mobile phone with GI standards.it can perfectly
compatible with Sam sung, Apple fast charge wireless function, to save more
time effectively and improve your charging experience
Product Outline
Applicable Devices
- Devices with built-in quick charge/normal charge wireless receiver (Samsung Note 8, IPHONE 8, etc)
- Devices with outer face wireless charging receiver (Samsung Galaxy S3, S4, S5, Note 3, Note 4, HUAWEI, LENOVO, XIAOMI, etc.)
- Devices with wireless charging receiver in its protection case iPhone 5/5s, Phone 6, iPhone6p, etc.)
Note: All devices must be Qi standard.
Instructions
- Connect the wireless charger with the AC source by power adapter, the wireless charger turns on, the indicator shows green color in 3 seconds and goes into the blue color in 1S seconds for standby mode.
- Put your phones onto the wireless charging area, phones start to charge and the indicator shows flashing blue color, once phones are full chartered, the blue indicator will keep lighting on.
- Light touch lamp switch, the lamp will light on, the lamp has 3 types of lighting mode, strong warm light, cold light, subdued light, then touch l more time to turn off.
Specifications
Model No. HT-12
Input voltage 5V2A 9Vl.67A
Charging efficiency. 70%-80%
Input power 18W max.
Output power 10W
Dimension: 11511510mm
Standard Accessories
1 LED Lamp Wireless Charger
1 USB Cable
1 User Manual
Attention
- Please keep the charger away from water or other liquid
- If you need to lean the charger, please make sure it is powered off
- Using Environment temperature remain 1-45( degree
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
Radiation Exposure Statement
This equipment complies with Canada’s radiation exposure limits set forth for
an uncontrolled environment. This equipment should be installed and operated
with a minimum distance of 20cm between the radiator & your body
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>