CLEAR DESIGN THREE60 Conference Sleigh LEG User Manual
- June 4, 2024
- CLEAR DESIGN
Table of Contents
TH–1
THREE60 CONFERENCE
SLEIGH LEG
Includes Optional Power and Wire Management Install
*General Guide | See Master Plan
THREE60 SLEIGH LEG
PARTS LIST
ITEM CODE| QTY| PRODUCT CODE|
---|---|---|---
GCN| 2| Angled Sleigh Leg|
CNS####| 1| Main Surface|
BASB72| 1| Surface Support Bar|
CNWG| 1| In-Surface Grommet|
Note: Install steps are the same for sitting and standing-height tables
PREPARE SURFACE
Carefully place the surface upside-down on the floor, a cushioned area is
preferred.
Measure from the surface edge to determine leg placement.
INSTALL ANGLED SLEIGH LEGS
Follow measurements and insert 15 screws per leg through the metal plate and into the laminate surface.
FLIP AND INSERT GROMMET
Insert wire management grommet.
OPTIONAL COVERED SLEIGH LEG
All steps for installation are the same, however, leg will be aligned with the grommet cutout on the table
Panel on leg will swing open to manage date and power cables.
THREE60 OPTIONAL POWER
PARTS LIST
ITEM CODE| QTY| PRODUCT CODE|
---|---|---|---
BPCONF2V2or BPCONF3| 1| In-Surface Power Module|
JC1| 5| J-Clips|
VB24| 1| Cable Vertebrae|
POWER THREE60
OPTIONAL POWER MODULE INSTALL
Attach 2 metal clips to the back of the module base then insert ithe pre-cut
holes in the surface.
OPTIONAL POWER MODULE INSTALL
Insert the plastic clamps into the holes on the bottom of the module. Rotate
and then push against the surface to clamp the module into place.
PARSONS THREE60
OPTIONAL POWER VERTEBRAE
Attach the vertebrae to the underside of the top panel. Insert woodscrews
through the top bracket and into the laminate panel.
Workspace made easy
210.648.2095 | mycleardesign.com
© 2021 Clear Design. All rights reserved.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>