Guangzhou Ruima Electronics TK-8308 Portable Battery Speaker User Manual

June 6, 2024
Guangzhou Ruima Electronics

TK-8308 Portable Battery Speaker

PORTABLE BATTERY SPEAKER
User Manual
TK-8308

Control Panel Function

  1. MIC input
  2. Power/VOLUME -&+
  3. ECHO: Echo volume adjustment
  4. MIC.VOL: Microphone volume control
  5. .DC interface (5V)
  6. Charging Indicator RED=Charging Light off = Fully Charged
  7. AUX input
  8. MODE/LIGHT(Long press to turn on/off light; Lightly press to enter into  selection for Bluetooth,FM Radio,AUX Input,USB,TF)
  9. Next track
  10. Play/Pause&TWS (Wirless Bluetooth Connection: under bluetooth mode,  press TWS button for around 3 seconds to pairing another TWS speaker; Under FM mode, lightly press Play/Pause&TWS to enter into automatic scan  and all the scanned radio stations will be saved automatically.)
  11. Previous track
  12. TF/USB input

SPECIFICATIONS

Power Output: 8W
Frequency Response
for main speaker: 38Hz-20KHz
Power Supply: DC5V

POWER SOURCE

1.Please charge the unit at least 4 hours before first time using.

2. Twist the dial clockwise/anticlockwise to switch on/off the unit.

CHARGE THE BATTERY

When the battery is charging, the CHARGE STATUS lights shows on the LED display  is red. After the battery has fully charged, the light turns off.

  1. Connect the USB charge cable to the DC5V interface of the speaker firmly.
  2. When the battery is fully charged, please disconnect the USB charge cable from  the speaker.
  3. The speaker works normally when charging.

POWER/VOLUME
Twist the dial clockwise/anticlockwise to increase/decrease the volume.

PREVIOUS/NEXT BUTTON
Under playing status, press PREVIOUS/NEXT button to get back to a previous or next song.

PAUSE/PLAY BUTTON
To stop playing the current track, please press PAUSE/PLAY button on the control  panel. Press it once again to continue playing.

MODE/LIGHT
Long press to turn on/off light.

Lightly press to enter into playing mode selection(Bluetooth,FM Radio,AUX Input, USB,TF).

AUX IN JACK

1. Connect an audio cable to the AUX IN JACK of the speaker and to the audio output socket on the external audio devices such as MP3 player, discman, etc, then select  LINE by pressing the MODE/LIGHT button on the control panel .

2.Play from an external audio device.

MIC IN JACK
Plug in microphone directly for playing.

USB JACK
Insert USB card directly for playing.

TF JACK
Insert TF card dirctly for playing.

FM FUNCTION
Lightly press MODE/LIGHT button to switch to FM mode. Press PLAY/PAUSE button on control panel for automatic searching and saving the radio stations, by pressing  PREVIOUS or NEXT you can select a previous or next radio station.

Bluetooth:
Long press MODE/LIGHT button on control panel to select Bluetooth mode. Simultaneously open the Bluetooth setting on your phone, tablet or any other bluetooth enabled audio device and select “TK-8308″(no need to match code),the unit and device will then connected via Bluetooth. Press the “NEXT SONG” and “PREVIOUS SONG” button on the control panel to select the song,  press ” PLAY/PAUSE” button to control the playing status.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not  cause harmful interference, and (2) this device must accept any interference received, including interference that may cause  undesired operation

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of  the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential  installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance  with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that  interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the  equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.

Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user’s  authority to operate the equipment

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals