HYPERX 926639 Pulsefire Haste 2 Gaming Mouse User Guide

HyperX Pulsefire Haste 2
User Guide

E’RE ALL GAMERS.

Overview

A Left click
button
B Right click
button
C Mouse wheel D DPI button
E Forward
button
F Back button
G HyperX 26K
Sensor
H Grip tape
Mouse skates

Installation

Connect the mouse to a PC or game console containing a USB 2.0 (High-Speed) or higher port.

Grip Tape

Pulsefire Haste 2 includes grip tape, which can be used for added control and comfort, if desired.

1. Attach the button grip tape for the left [1] and right [2] mouse buttons, with the pointed end facing the forward direction of the mouse.
2. Attach the side grip tape for the left (3] and right [4] sides of the mouse, following the shape of the mouse Grip tape adhesion may weaken over time, or via repetitive removal and re-use of the original grip tape.

Replacement Skates

Pulsefire Haste 2 includes an extra set of PTFE skates, in case the preinstalled skates are lost, damaged, or worn. To replace the skates. follow these instructions

1. Remove the skate by gently wedging a flat tool (e.g., small flathead screwdriver, plastic card, or similar tool) under the skate.
2. Lift and pry the skate from the mouse
3. Remove adhesive residue and debris from the mouse – A clean dry surface will provide optimal adhesion.
4. Peel the replacement mouse skate from the backing paper and install on the mouse (Use tweezers if needed).
5. Remove the outer protective film.

DPL
There are 4 default DPI presets.
Up to 5 DPIlevels can be stored on the mouse. Customizing and saving DPI levels can be done within HyperX NGENUITY software.

Polling Rate

Switch between 1000Hz (default) and 8000Hz polling rate.

1. Hold down the DPI Button.
2. While holding down the DPI button, connect the mouse to a computer.
3. Continue holding the DPI button until either color (see table below) appears on the mouse wheel.
4. Release DPI button.
   The LED will blink Red (1000Hz) or Blue (8000Hz).
   Other polling rate options can be selected within HyperX
   NGENUITY software.

Factory Reset

Press and hold DPI button and Mouse wheel button simultaneously, until the mouse LED flashes red momentarily and disappears once reset has completed.
Factory Settings

• DPI Levels — 400 / 800 / 1600 / 3200
• Polling Rate – 1000Hz
• RGB Lighting – Cycle effect
• Button Assignments

Software

To customize lighting, DPI, macro settings, and more, download HyperX NGENUITY software at hyperx.com/ngenuity

Cleaning and Care

To clean your mouse, follow the instructions below

1. Unplug the mouse from your device.
2. Wipe gently with a slightly damp, soft cloth (e.g., microfiber cloth).
   Avoid using harsh cleaners such as products containing bleach

Questions or Setup Issues?

Contact the HyperX support team at hyperx.com/support You may also find the User Guide or Quick Start Guide on the support page.

Specifications

Mouse Specifications

1 Per-LED RGB lighting customizable with HyperX NGENUITY software 2 Default 1000Hz polling rate. Use onboard combination to switch to 8000Hz polling rate or configure with HyperX NGENUITY software
SKU Numbers

References

• NGENUITY – HyperX US
• Support – HyperX ROW

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>