SHARP AM-475T Dolphin Electric Iron Instruction Manual
- June 13, 2024
- Sharp
Table of Contents
OPERATION MANUAL
ELECTRIC IRON
DOLPHIN
MODEL AM-475T, AM-575T
Please see the date of manufacture marked on the product
Thank you for your trust in products of Thai City Electric Co., Ltd.
In order to use electric iron in efficiency way. Please read the instructions
manual carefully before using this appliance.
REV.1-2566
SAFETY INSTRUCTION
Please read the warning and instruction for use carefully before using this appliance and comply strictly for own safety and to prevent the damage that may occur on your property.
- The appliance s to be supplied through a residual current device (RCD) having a rated residual operating current not exceeding 30 mA.
- This appliance is considered to be suitable for use in countries having a warm damp equable climate. It may also be used in other countries.
- Tropical climate.
WARNING
- Do not leave the iron unoffended why it s connected the mains supply.
- Do not use the nylon scrubbing brush, tanner or alcohol for polish the iron,
- Do notimmerse the stein water, it may cause electric leakage or damage of the electric Ron.
- Never share the wall outlet with other appliances.
- When you have fished ironing\and even when you leave the iron for & short while, adjust for low temperature and put 1t on the front stand.
- When placing the iron on it stand, ensure that the surface on which the stand is placed is stable,
- The front is not for be used fit has been dropped, if there are visibly signs of damage or 1t is leaking.
- After use, tum affront and unplug,
- Never connect the plug with your wet hand as ft may be dangerous from electric leakage.
INSTRUCTION FOR USE
- Insert the plug into the wall outlet firmly and when disconnecting, hold the plug and pull it out without touching the power cord.
- This appliance is not intended for use by persons (including chidden) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision ;)r i? fit[uctk’mt conceding use of the appliance by a person responsible: or their sale.
- If the power cyttid or plug is damaged. The power cord must be replaced by the manufacturer, it aftersales sender or slimily qualified persons unorder 10 avoid danger a hazard.
- Chidden should be supervised to ensure that they do not play with the appliance.
DESCRIPTION OF PART
SPECIFIC INFORMATION
MODEL | AM-285T |
---|---|
Rated voltage (v) | 220 |
Rated frequency (Hz) | 50 |
Power consumption (w) | 1,100 |
Outside dimension (WxHxL) (mm.) | 120 x 130 x 249 |
HOW TO USE
Be sure that the rated voltage is 220V only before use.
- Put the iron on Its heel.
- Tum the knob to the OFF position.
- Insert the plug securely into the wall outlet and select desired power level, suitable to fabric.
Position| Fabri c
---|---
A (Synthetic)| Synthetic, Acrylic
B (Nylon, Silk)| Cotton and Linen
C (Wool)| Silk, Rayon and Nylon
D (Cotton, Linen)| Wool, Felt
Wait for 2 minutes to warm. If uncertain of cloth fabric to iron, start at the seam of cloth. If the iron sticks to the cloth, hurry to take the iron away. Then tum the knob to lower level before ironing with high power level.
- Lamp indicator will lights up when adjusting to desired power level and will go off when power level is working. (The iron heats up quickly begin by ironing those fabrics that are ironed at low temperatures)
- After use, tum the knob to the “OFF” position before pulling out the plug from the wall outlet.
BEFORE FIRST USE
- Remove any sticker from the sole plate and clean it with a soft cloth.
- The iron may give out some smoke when using it for the first time. After a short while this will cease.
THE SPECIAL FEATURE
Model : AM-475T, AM-575T
The iron surface is coated with CERAMIC COATING, which is heat resistant,
harmless to health and easy for cleaning.
RECOMMENDATION FOR ENERGY SAVING
-
Aloof clothes should be ironed at one time.
-
Start ironing the articles that require the lowest ironing temperature, such as those made or synthetic fibers.
-
Tay to iron quickly with less time by:
« Selecting suitable power level that helps iron clothes smoothly.
« Sprinkling clothes with water that helps iron clothes quickly.
« While washing and parching clothes, try not to crumple cloth that helps time save to iron. -
Plug off the iron before finishing 2-3 minutes.
-
Should not use the iron in air-condition room.
CLEANING AND MANTENANCE
- Powder stain can easily be removed by dipping a soft cloth in vinegar and wiping the surface of iron.
- Keep the sole plate smooth avoid hard contact with metal objects.
- After use, disconnect the plug from the wall outlet and put iron its heel then let it cool down.
- Check the power cord for damage.
*Avoid the iron on the hard or shape parts of cloth such as zipper, button, etc.
INITIAL INSPECTIONS
Problem | Check |
---|---|
1. If the iron is not hot. | « Whether there is no electricity in the wall |
outlet.
« Whether the power cord or plug is out of order.
2. If iron s stuck on cloth while ironing.| « Iron’s surface is dirty or not.
« Set the power level unsuitable to the cloth fabric.
MANUFACTURED BY FEDERAL ELECTRIC CORP., LTD.
64/1 Moo 4 Kinkade Rd., Rajatheva, Bangplee, Samutprakarn 10540
Sole Distributor in Thailand
THAI CITY ELECTRIC CO., LTD.
1643/4 New Phetchaburi Rd., Iviakkasan, Ratchathewi, Bangkok 10400Tel. 0 2333
311iCall Center o 2254 5000
E-mail: calIcenter@thaicity.co.th
www.thaicity.co.th
www.sharp-weeclub.com
sharpweeclub
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>