THE HOME DEPOT W00025 1-Light Round Outdoor Wall Lantern Sconce Instruction Manual
- June 13, 2024
- THE HOME DEPOT
Table of Contents
THE HOME DEPOT W00025 1-Light Round Outdoor Wall Lantern Sconce
IMPORTANT SAFETY INSTRUCTIONS
- Warning: If any special control devices are used with this fixture, follow the instructions carefully to assure full compliance with N.E.C. requirements. If there are any questions, contact a qualified electric contractor.
- Warning: This product can expose you to chemicals including lead, which is known to the State of California, to cause cancer or birth defects or other reproductive harm. For more information, please go to www.P65Warnings.ca.gov
- Caution : Electrician installation highly recommended. All glass is fragile, use care when handling glass component(s) and or lamp(s). Read instructions carefully and turn electricity off at the main circuit breaker panel before beginning installation.
Important Notice
This is a generic instruction sheet used for various fixtures.
The finish, numbers of heads/arms, and style of fixture / glass / shade /
diffuser may vary.
(Required Supply Circuit: 120V, 60Hz. Bulb Type: 1E26100W Max)
Compatible Bulb Type (NOT Included)
The mostly suggested bulb type is a 11W LED ST58 or A19 bulb
COMPONENTS INCLUDED IN THE PACKAGE
Fixture with hardwares
Parts included in parts bag.
Parts X 2 for 2 pack item
ASSEMBLY & INSTALLATION STEPS
- Open the box from top, take out all the components, parts bag and manual from the box carefully.
- Check all the components against the parts list. Make sure get each parts on list. If any parts missing and glass damage, please contact the manufacturer at goldhill_lighting@hotmail.com to get a replacement. Parts are NOT included for which is shown as 0 under QTY.
PARTS LIST (Parts QTY X 2 for 2 pack item)
Part Name
| QTY| Code| | Part Name| QTY| Code
Junction Box| 0| A| Cap Nut| 2|
H
Leading Wire
| 2| B| Wire Nut| 3| I
Universal Mounting Bracket| 1| C| Wire| 2|
J
(1.5″) Mounting Screw
| 2| D| Socket| 1| K
Stud| 2| E| Shade| 1|
L
Back Plate
| 1| F| Socket Ring| 1| M
Washer| 2| G| Bulb| 0|
N
- Refer to the illustration while doing assembly and follow the steps as below:
I Lock the shade (L) onto the socket (K) by screwing on the socket ring (M).
II Screw the bulb (N) onto the socket (K).
III Thread two studs (E) onto the mounting bracket (C) at proper position.
IV Attach the mounting bracket (C) to the junction box (A) by two mounting screws (D). Adjust the mounting bracket to a horizontal level.
V Connect wires according to the wiring diagram as below.
VI Attach the backplate (F) to two studs (E) and fix with two washers (G) and cap nuts (H).
Illustration of assembly and wiring
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>