Serta ME6 Motion Essentials VI Power Base Installation Guide
- June 13, 2024
- Serta
Table of Contents
Serta ME6 Motion Essentials VI Power Base
QUICK SETUP GUIDE
See Owner’s Manual for complete safety and operating instructions.
PART LIST
Before discarding packing materials, ensure all parts are accounted for.
Some parts may be attached to base or inside boxes. Please inspect carefully
Only included in Twin Long and Cal King Split Bases. Not included in Divided King.
-
Connecting Strap
-
Sync Cord
-
Wireless Remote
-
(3) AAA Batteries
-
Mattress Retainer Bar
-
(6) Legs & Washers
-
Power Cord
-
Power Supply
-
Battery Backup Strap
-
Manual
-
Warranty Card
-
Quick Setup Guide
INSTRUCTIONS FOR USE
STEP 1
Always use two people when setting up, moving or flipping base.
Place bed base box in a desired location with bottom of box facing up.
Remove the bed base from the box. Unfold the bed making sure to keep the bottom of the bed facing upwards.
STEP 2
Headboard brackets are optional and can be purchased from Ergomotion separately. If installing a headboard, please see headboard bracket installation instructions or Owner’s Manual.
Legs are shipped fully assembled. Alternative heights in 3″ increments can be
achieved by removing leg segments.
To install the legs, thread the leg into frame, and tighten by hand. Do not
over tighten.
STEP 3
To sync two bases with the Sync Cord, see installation instructions in Owner’s Manual
Locate the battery backup strap. Store the battery backup strap in a
convenient location for emergency use.
For operating instructions, see owner’s manual.
STEP 4
Uncoil input cord (connected to control box’s power port) and plug it into Power Supply
STEP 5
Uncoil Power Cord and connect to Power Supply. Place Power Supply on ground and extend from base. Ensure that Power Supply and all attached cords are directed toward the desired surge protector.
STEP 6
Carefully flip the base over onto its legs.
Important: Two people are required to move the bed base. Do not drag frame
across the floor or rest frame on its side, as excessive pressure may damage
the legs.
STEP 7
Plug the base into a power source. A surge protector is strongly recommended. Unauthorized modification or failure to use a wall outlet or surge protector could void the electrical portion of your warranty.
STEP 8
Install (3) AAA batteries in remote control.
Test functions before placing mattress on base to verify proper setup.
Press FLAT to return base to a flat position.
STEP 9
Insert each end of the mattress retainer bar into the holes at the foot of the base. Make sure the bar is secured.
REMOTE OVERVIEW
CHILD SAFETY LOCK
Activate Child Lock
To activate Child Lock, press and hold the HEAD UP and FOOT UP buttons together for three (3) seconds until the remote backlight flashes twice.
The remote is now in Child Lock. Pressing any buttons while in Child Lock will yield no movement to your adjustable base.
Deactivate Child Lock
Press and hold the HEAD DOWN and FOOT DOWN buttons together for three (3) seconds, then hold HEAD UP and FOOT UP for three (3) seconds until the remote backlight flashes twice.
The remote is no longer in Child Lock. The remote and adjustable base will work normally
CUSTOMERS SUPPORT
Setup is now complete!
For more information please see Owner’s Manual.
For customer support, visit www.ergomotion.com or
call:
1-888-550-3746
Nationwide Customer Service
Phone 1.888.550.3746
Fax 1.805.979.9399
Email info@ergomotion.com
Web www.ergomotion.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>