Serta USAN1022780-1 Motion Essentials Adjustable Base Bed Instruction Manual

Serta USAN1022780-1 Motion Essentials Adjustable Base Bed

Specifications

• Actuator rating : 24V,3A (Max)
• Max.weight limit : 800 LBS
• Dorsal angle: 0-70°
• Leg angle: 0-45°

Wireless Remote Instruction

Brief introduction of remote control(W) panel function and install the battery

• Function analysis of six key wireless key
• S1 key: head up
• S2 key: head down
• S3 key: leg up
• S4 key: leg down
• S5 key: both up
• S6 key: both down
• The S1-S6 keys are inching type, release to stop

1. slide down the back cover
2. Install the battery
3. slide up the back cover

• a.Please install the battery(S) as shown, pay attention to the battery polarity.
  if you can’t slide off the back covers smoothly , use hammer or other heavy stuff to knock the edge slowly.

• b. Build connection
  Before attaching motor to bed frame, make sure the white slider block stays invisible, If not,press the S6 button.

• c. If you encountered a power outage, you can install the spare battery on the motor.
  The spare battery can only be used to flat the frame and MUST be removed after the frame got flat!

PARTS LIST

Assemble the Frame

1. Please check that you have all the parts listed before you do not continue assembly, please contact us immediately.
   NOTE: Please do not tighten all the hardware completely until the entire assembly is completed!

2. Build Frame Base and Mount 6 Legs  Round hole facing up( Part C)
   The left and right brackets(A1,A2&B1,B2) are placed upside down and placed symmetrically;

3. Build lift bars
   The left and right bars(F,G,H) are connected with the driving lever, lever(J), please align the arrows as indicated.

4. Connect Foot Lift bars on Frame Base

5. Assemble the circled part , pls check circle

6. Assemble the square part, pls check square

7. Connect Head Lift Bars on Frame Base

8. Mount motor

9. Insert the motor into the driving lever, please pay attention to the direction of the motor, check the mark head and foot. Then buckle the back covers into place.

10. If the back covers don’t slide in,lift the driving lever until it slides in.
    Turn the bed frame over ,then place the 7 bed boards in the direction of the arrows and screw them with M8*35(Y2) screws.

11. Assemble the Frame
    Before put on cloth cover, push S5 button till the bed elevate to the highest degree.

12. Starting at the end of the bed, cover the left corner first.

13. Spread out the cover and insert the board into the edge of the right side cover.

14. Lift the cloth cover and pull up the cloth cover till the board insert the cloth cover completely as 2 and 3 in picture. Cover the head of the bed as Step 1-3.

15. Push S6 button to flat the bed. Attach the velcro tape of the cloth cover to the board.

16. Attention: Do not pull the face cover horizontally.
    Raise the head to put on the cloth cover, put down the head after all the corner are wrapped.

17. Push the retainerbar
    At the end of the bed,push the retainerbar into the plastic slider

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>