2E PPS1210 Portable Power Station User Manual

2E PPS1210 Portable Power Station User Manual

Technical parameter

• Battery capacity

• Weight

• Wireless output

• Size.

• USB-C output

• DC 12v output

• Solar energy

• ACoutput port

• USB output port

• Battery

• Battery cycle
  

• Operating Temperature

• Charging Temperature

• Protection system

• Warranty

• Certificate

• Lighting

Package contents:

Power Switch (click on to start, press 3 seconds to shut down)

Preca for use

1. Please read all the safety warnings before use and always follow the basic precautions when using this product. Warranty does not cover damages caused by failure to follow instructions.
2. When using the device for the first time, it is recommended to fully charge it in order to avoid inconveniences during use due to lack of power. After the device is fully charged, the cooling fan will continue to operate for approximately 2 minutes after the power cord is unplugged (specific time may vary depending on temperature).
3. Close supervision is required when using this product around children to reduce the risk.
4. Charge the product at least every three months to preserve the battery lfe.
5. Low temperature may affect the battery capacity, the product can be charge in the temperature range of 0 to 40°C. and used i the temperature range of – 10 to 40°C.
6. Place, charge and store the product in a well-ventilated place.
7. Wipe the product clean with a dry cloth.
8. When the product is not in use, unplug the power cord from the outlet.
9. After the end of use, the built-in fan will continue to operate to reduce the temperature of the device to the required value for about 30 minutes (the time may vary depending on the ambient temperature). Rapid charging and discharging, current over 15, or too high temperature may cause the device to automatically turn off the power.

Safety warning:

1. Use of accessories recommended or sold by non-professional product manufacturers may result in electric shock or
2. Do not use damaged wires or plugs or damaged output cables with this product.
3. Never restrict the ventilation of the product.
4. Do not disassemble the product. Doing so may result in unpredictable risks such as fire, explosion, or electric shock.
5. Avoid exposing the product to rain or using the product in humid environment.
6. Do not use or store the product in a high temperature environment (direct hot sunlight or hot car interior), otherwise the internal battery may overheat, catch fire or fail, shorten its lifespan, and incur other risks.
7. In case of fire, use dry powder fire extinguishers for this product. Do not use water fire extinguisher, which may cause electric shock.
8. Avoid getting dust or foreign objects inside the device, otherwise it may easily cause damage to its internal components.

How to charge the product

Fully charge the device before using or storing. Blue indicator will flash during charging. The LED screen will display the current charge level and charging power.

AC 1000W fast charging, 1 hour to 80%; 1.5 hours to 100%

300W Solar panel, about 4 hours to 100% (the charging time is determined by the intensity of sunlight).
Supports charging by MPPT solar PV panel

Actual performance indicators may vary depending on usage environment, usage method and other factors.

Cold Weather
Cold weather can influence battery capacity. In sub-zero temperature (<0°C), you may be able to discharge the product, but you should not charge it. Otherwise, the battery of the product would be greatly damaged and the capacity may not even be recovered.

Attention: The operating environment should meet all requirements in this manual. Make sure that the air inlet/outlet is not blocked.

1. Press button 7, the device will start up about 60 seconds after the screen backlight automatically turns on.
2. Pressing the 2 4 8 9 buttons turns on the appropriate output port to power the external device.
3. When the power output port is not in use, press the 24 8 9 buttons to turn it off to save power.

Application scenario

1. Outdoor
   Car equipment: car fridge, car vacuum cleaner, pump and other car equipment; Camping equipment: garden electric tools (power tools such as blowers, lawnmowers, electric drills, electric saws), BBQ grills, LED lights, etc.

2. Indoor
   Refrigerator, kitchen devices such as kettle, toaster, blender, coffee maker, gas boiler, laptops, phones, lighting, etc.

Examples of loads

1. Most electrical appliances in the market apply to the specifications of 12V/30A (XT60 or SPC45), 12V/10A, cigarette lighter, USB-A, and USB-C output ports of charger. But still, the charging of some products may activate the over-current protection if it generates an instantaneous high current at the moment of starting.

2. Charger can power electrical products with 1000W or less rated power. Though the figure is under 1000W, overload
   protection willstill be activated when the appliance generates a massive instantaneous start-up  power. Therefore, it’s recommended to apply charger to electrical products with lower-rated power.

3. If an output over-current, overload, or short circuit occurs, device will turn off the corresponding output port. Then it will automatically start again at an interval of 15s). If the output repeatedly stops, turn the equipment off. Please get in touch with the seller or maintenance group first for professional help.

4. When the battery level drops to 0%, the DC and AC output will automatically turn off. Please check the battery level before using device to protect and enhance battery cycle life.

5. This device supports charging and discharging simultaneously, and please keep the equipment laid flat during use, charging, and discharging.

Estimation of operating time

Smartphone
87-100Times 10w

Television
Around 10-11hrs 75W

Electronic Tools
Around 9-10hrs 80w

Refrigerator
Around 8-9hrs oW

LED Light Bulb
Around 37-42hrs 20w

Gas boiler
Around 8-10hrs 100w

1050Wh x DOD x n + (load power) = operating time
Note: DOD is the battery discharge depth, n is the local inverter efficiency. And the units of load power and charging time are Watt and Hour. DOD=80%, n=90%

External device is notcharging| The device is not properly connected to the charger| ake sure the product s properly connected to the charger. Checkfor poor contact in the connections
---|---|---
The contact is good, but the charging indicator is not on| The charger might be broken, please contact after-sales service
The charging indicator is on, device is still not charging| The device might be broken, please contact device after-sales servi jice
Charger does not output power| The equipment s not properly connected to the charger| Make sure the equipment is properly connected to the charger.Check for poor contact in the connections.
The output port switch is not turned on| Turn on the output port switch
Low output power| Charge the charger
till no output power after eliminating 1.2.3 points| The charger might be broken, please contact after-sales service
Charger interruptspower output| The rated power or instantaneous starting power of the equipment used is greater than the power of the product| Select higher power energy storage products
The alarm symbol appears on the display screen. A beep sounds and the product automatically turns off the output for 15 seconds| Ashort circuit has occurred in the equipment being used.Please contact the after-sales service of this equipment
Power output stillinterrupts after eliminating 1.2.points| The charger might be broken, please contact after-sales service

FAQ:

1. Can this product be carried on a plane?

No, because this product contains high capacity battery. In accordance with international air transport Warranty standards, the transportation of products with batteries with a capacity of more than 100 Wh is prohibited.

2. If the power of the equipment is within the rated output of the

product, can it be used?

a. If the power consumption of the product s less than 20% of the total power of the charger, it can be used atthe same time with other products b. products with a rated or peak power that exceeds the allowable parameters cannot be used with this charger

3. Why does the device make a sound while using it?

The product uses an air-cooling system, and the built-in fan is better conducive to heat dissipation. A little noise during operation is normal.

4. Is it normal for the charger to get warm while charging?

Charger heating when charging is a normal phenomenon, the standard temperature of the device when charging is in line with national safety standards, you can rest assured to use it!

Warranty

The warranty period is one year.
The warranty period starts from the date of purchase by the consumer.

The warranty does not cover the following cases:

1. Cosmetic damages, scratches on the body;
2. Disassembly and repair by non-authorized staff without permission;
3. Product performance failure caused by human factors.
4. Damage caused by irresistible factors such as natural disasters, lightning and accidents

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>