2E-OPS-300 Portable Power Station User Manual

2E-OPS-300 Portable Power Station User Manual

WARNING

1. Please avoid using the product near high temperature, high humidity, direct sun environment and fire place.
2. Do not disassemble or modify this product, it will cause malfunction and fire.
3. Please discard or recycle the product according to the methods prescribed by local laws.
4. Be careful not to drop the product from a high place an  give the product a strong impact.
5. Keep or use the product in a place out of the reach of children.
6. Please use our company’s genuine accessories. The damage caused by the use of non-genuine accessories cannot be repaired free of charge.
7. Please leave a space of about 30cm away from the side suction and exhaust ports, so as not to affect the heat dissipation of the product.
8. When not using this product, please turn off the power and unplug the power cord. Please avoid storing the product in a place exposed to direct sunlight with high temperature and humidity.
9. For long-term storage, please consume power from full power to no power once every 3 months, and then recharge to about 50%.
10. Please do not use this product and its accessory cables and connecting equipment when there is a defect.

Please do not store the product for a long time in extremely high and low temperature places such as in the car and in the field warehouse to avoid shortening the battery life.

Packing List

After opening the package, please check whether the product appearance is damaged or lack of accessories.

Product introduction

1. DC5.5*2.1 Input Only
2. Cooling Fan
3. Power Station Description
4. AC230 VDE(EU) Socket
5. USB-A Output
6. DC5.5*2.1 – 12V Output Only
7. Type-C Input / Output PD100W
8. Main Power Button / DC Output Switch
9. LED Screen Display
10. AC Output Switch
11. LED Torch Switch
12. LED Torch

1. USB-A Output and Type-C Output, no need to do any actions, connect your device, the Power Station will be discharged automatically.
2. Press the Light Button (11) for 3-5 seconds, the lighting will be turned on, click the light button to switch different modes (Weak/ Strong/Blink).
3. The following steps must start the Power Station: Press Power Button (8) for 3-5 seconds
   a. When the Screen is lighted on, press the Power Button again to start DC Output, then 2*DC5.5(at the bottom of the left side of the screen, 6) can be output.
   b. Press the AC Power Button (10) for 3-5seconds,the Screen show moment Voltage 230V means AC Socket can be output. Press AC Power Button again for 3-5seconds to cut off the AC Output.

Notice:

1. It is recommended that the loaded device should not exceed 300W, and the excessive power may cause output protection or burn out the product
2. The Cooling Fan will be started when the total output Power >=100W
3. USB-A QC3.0-18W have no output when DC Charging Input
4. DC input will be cut off @85% battery level when DC+PD Input same time

Technical Specification

OUTPUT

AC OUTPUT| Rated Voltage| 230 V
Rated Power| 300 W/288 Wh
Peak Power| 600 W @Is
Over Load| 350 W@IOs
Frequency| 50 Hz
DC12V OUTPUT| DC5.52.1-1| 12 -13 V/10 A(Share)
DC5.52.1-2| 12 -13 V/10 A(Share)
TYPE-C OUTPUT| Type-C| PDI 00W
USB-A OUTPUT| USB-A1/A2| 5V/2.1 A
USB-A3| 5V/3 A, 9V/2 A,12 V/I.5 A
LED LIGHT| Power 7 W(Max.)/560-840 Lums Continuous lighting
Lighting (Weak/Strong) / SOS (Quick/Slow Flash)
INPUT
INPUT| DC5.52.1: 5-20 V/5 A, 100 W (Max.)
DC5.52.1: Solar Attached, 100 W (Max.)
Type-C: PDIOOW (Max.)
Support Type-C+DC Input 200 W (Max.)
BATTERY
288 Wh/80000 mAh@3.6 V or 288 Wh/20000 mAh@l 4.4 V
SIZE/N.W
225′ 1214220 mm/2.86 KG

Solar panel connection

Our products can be connected to solar panels and can be charged through solar panels. Solar panel input can be the most maximum 100W

• Solar panel charging power, according to the weather and climate conditions

Connecting Pattern

Car charging

This product can be charged by the cigarette lighter in the car with an DC cable or PD Cable.

Connect Car Charger to the cigarette lighter in the car and the DC5.5 port OR Type-C port on the side of the product, turn on the engine of the car, and the LED of this product will show the input power.

• On-board charging should be carried out with the car engine turned on. If the engine is not turned on, the battery might run out.
  

Warranty Card

Warranty Card

Model|
Name|
Address|
Tel|
Mail|
Name of store|
Buying of the store|
|
Please fill in all the above items.|

This product provides a 12-month warranty service from the date of purchase

• If there is a quality problem within the range of normal use, we provide warranty service.
• After purchasing our company’s products, please keep this product together with invoices and other items. When maintenance services are needed, please provide information according to our company’s request.
• In the case where the warranty is damaged or altered, and no stamp of the sales store on the warranty, the warranty service may be not be provided.
• Damage causes by use beyond the normal range of use is not covered by the warranty service.
• The content of the warranty scope shall be subject to the content recognized by the company.
• Even within the scope of the warranty, sometimes it will be exchanged for products with the same function. The shipping and repair fees for products outside the warranty range shall be paid by the customer.
• Sometimes the specifications and functions of the product will be updated without prior notice.

References

• Сервіс Центр

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>