HEXBUG NIGHT HAWK Elite Raceway RC Car Installation Guide
- June 13, 2024
- HEXBUG
Table of Contents
Installation
Guide
3×AAA/R03 1×Li-Fe
PILES INCLUSES
NIGHT HAWK™
BC
Get Started
Install Body
Remove Body
Transmitter & Battery
Install
Pairing Power on the
controller
If the controller LED is blinking quickly, make
sure the WHEEL and TRIGGER are centered.
Once the controller LED starts
blinking slowly, flip car over and press the power button on the car for 2
seconds.
The controller LED turns solid red when it is
paired with the car.
Transmitter
- LED Indicator
- Power Button
- Left Steering Trim
- Right Steering Trim
- High & Low Speed
- Steering Sensitivity Switch
- Steering Wheel
- Throttle Trigger
- Battery Door
Controls
Move trigger forward once to brake, move
trigger forward twice to reverse.
Steering Sensitivity
Speed Steering Trim If car is turning
right without touching the steering wheel, press left trim button to correct
the car as needed.
If car is turning left without touching the
steering wheel, press right trim button to correct the car as needed.
Chassis: Charging
Body Mods
How to use the tool
Barriers
Front Bumper
Rear Bumper & Exhaust
Replace Spoiler
Replace Hood
Replace Roof
Engine Cover
Replace Side Skirts
Install Decals
Install Head & Tail Lights
Chassis Mods
Wheel & Tire
Replacement
Replace
Front Suspension
Replace Rear Suspension
Change Speed
Steering
Link
RWD, FWD, AWD/ RWD, FWD,
AWD
Remove Rear Differential
Documents / Resources
|
HEXBUG NIGHT HAWK Elite Raceway RC
Car
[pdf] Installation Guide
68126TX2G4, 68126RX2G4, NIGHT HAWK, NIGHT HAWK Elite Raceway RC Car, Elite
Raceway RC Car, Raceway RC Car, RC Car, Car
---|---