HEXBUG HEX MODS Pro Series Elite Raceway Customizable RC Cars Instruction Manual
- June 12, 2024
- HEXBUG
Table of Contents
HEXBUG HEX MODS Pro Series Elite Raceway Customizable RC Cars
Product Information
The product is a motorized device with multiple buttons labeled A, B, C, and D. It also has cautionary information regarding the motor’s temperature.
Product Usage Instructions
- Push the button labeled A twice.
- Push the button labeled A once.
- Push the button labeled A six times.
- Push the button labeled A once.
- Push the button labeled A twice.
- Push the button labeled A six times.
- Push the button labeled A twice.
- Push the button labeled A twice.
- Push the button labeled D four times.
- Push the button labeled C twice.
- Push the button labeled A twice.
- Push the button labeled C twice.
- Push the button labeled D four times.
- Push the button labeled A twice.
- Push the button labeled A twice.
- Push the button labeled D four times.
- Push the button labeled A twice.
- Push the button labeled A twice.
- Push the button labeled A twice.
- Push the button labeled D four times.
- Push the button labeled C twice.
- Push the button labeled A twice.
Note:
The numbers in the text extract refer to specific steps in the product usage
instructions. Please follow the provided sequence to operate the device
correctly.
Installation
Install Rear Differential
CAUTION:
Motor may be hot to the touch. Take caution when touching or changing out
motor after continuous play. 
Install Front Differential
HOW TO INSTALL BATTERIES
- Open the battery door with a screwdriver.
- If used batteries are present, remove these batteries from the unit by pulling up on one end of each battery. DO NOT remove or install batteries using sharp or metal tools.
- Install new batteries as shown in the polarity diagram(+/-) inside the battery compartment.
- Replace battery door securely.
- Check your local laws and regulations for correct recycling and/or battery disposal.
BATTERY SAFETY INFORMATION
Batteries are small objects. Replacement of batteries must be done by adults. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the toy. Dispose of used batteries properly. Remove batteries for prolonged storage. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (i.e. alkaline/standard/rechargeable). Using rechargeable batteries is not recommended due to possible reduced performance. Rechargeable batteries are only to be charged under adult supervision. Replaceable-rechargeable batteries are to be removed from the toy before being charged. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.
Disposal:
Requires 1 x Li-Fe & Requires 3 x 1.5 V (RO3) batteries (INCLUDED) .
Batteries or battery packs must be removed for recycling and proper disposal.
When this product has reached the end of its useful life, it should not be
disposed of with other household waste. EU legislation for Electrical and
Electronic Equipment and Batteries, requires these to be separately collected
so that they can be treated using the best available recovery and recycling
techniques. This will minimize the impact on the environment and human health
from soil and water contamination by any hazardous substances, decrease the
resources required to make new products and avoid using up landfill space.
Please do your part by keeping this product out of the municipal waste stream!
The “wheelie bin” symbol means that it should be collected as “waste
electrical and electronic equipment”. You can return an old product to your
retailer when you buy a similar new one. For other options, please contact
vour local council.
FCC STATEMENT
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for Class B digital devices pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference to radio communications. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this toy does cause interference to radio or television reception (you can check this by turning the toy off and on while listening for the interference), one or more of the following measures may be useful:
- Reorient or relocate the receiving antenna
- Increase the separation between the tov and the radio or the TV
- Consult the dealer or an experienced TV-radio technician for help.
NOTE:
Changes, adjustments or modifications to this unit, including but not limited
to, replacement of any transmitter component (crystal, semiconductor, etc)
could result in a violation of FCC rules under part 15 and/or 95 and must be
expressly approved by Spin Master Ltd or they could void the user’s authority
to operate the equipment. Spin Master Inc., PMB #10053, 300 International
Drive, Suite 100, Williamsville, NY 14221. To contact the responsible party
please visit fcc.spinmaster.com.
CAN ICES-3/B)/NMB-3/B)
CANADIAN Class B statement: This device contains licence-exempt
transmitters/receiver (s) that comply with Innovation, Science and Economic
Deve opment Canada’sficence-exempt RS-S1srOperation is subject to the fol
owing two onditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Spin Master International B.V. hereby declares that the radio equipment type HEXBUG® NI GHT HAWK™ is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: http://doc.spinmaster.com.
- Frequency Band(s): 2 416 MHz – 2 466 MHz/ Maximum radio frequency power transmitted: < 1 OdBm
The transformer, power supply or battery charger used with the electric toy shall be regularly examined or damage to the supply cord, plug, enclosure or other parts, and in the event of damage, it shall not be used until the damage has been repaired.
WARNING:
CHOKING HAZARD – Small parts. Not suitable for children under three vears. DO
NOT put in nose or mouth.
- Retain this information, addresses and phone numbers for future reference.
- Batteries are only to be charged by persons of at least 8 vears old.
- This toy is only to be connected to equipment bearing either of the following symbols.
- This toy is only to be connected to equipment bearing either of the following symbols.
Patents
patents.spinmaster.com.
Juguete Importado por: Spin Master México, S.A. de C.V., Av. Insurgentes Sur No. 1070 piso 8, Colonia Insurgentes San Borja, Alcaldía Benito Juárez, C.P. 03100, Ciudad de México. R.F.C. SMM050627V48 Atención al cliente: 800 9530147.
TM &@ Spin Master Inc. Spin Master Ltd., 225 King Street West, Toronto ON M5V 3M2 Canada
- Spin Master Inc., PMB #10053, 300 International Drive, Suite 100, Williamsville, NY 14221
- Spin Master International B.V.. Kingsfordweg 151, 1043 GR Amsterdam. NL
- Spin Master Australia Pty Ltd, Level 9, 205 Pacific Hwy, St Leonards, NSW 2065; 01800 316 982
- Spin Master Toys UK Ltd. Boston House, Boston Drive, Bourne End, Buckinghamshire, SL8 5YS, UK.
Head to HEXBUG.com/HEXmodsTips for helpful mod tips.
For more options check out the Pro Series Elite™M at your local retailer.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>