PCD PL04 Mobile Phone User Guide
- June 12, 2024
- PCD
Table of Contents
PCD PL04 Mobile Phone
Product Information
- Model: PL04
- Features:
- VGA MP3/MP4
- FM Radio
- MicroSD Card slot up to 64GB
- Bluetooth
- Video player
- 1.77″ VGA LCD screen
- 48MB RAM | 128MB ROM
- 800mAh battery
- Manufacturer: PCDLATAM
- Website: www.pcdlatam.com
- Address: 7651 Southland Blvd. Orlando, FL 32809
Product Usage Instructions
- Remove the battery cover.
- Remove the battery.
- Place the SIM card and/or microSD in their respective slots, ensuring that the gold contacts are facing down.
- Replace the battery and battery cover back into the device.
- Turn on the device.
Note: For any further assistance or troubleshooting, please contact the manufacturer or refer to the user manual.
Declaration of Conformity:
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
CAUTION: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Note: This device and its antenna(s) must not be co-located or operated
in conjunction with any other antenna or transmitter.
Thank you for purchasing this innovative PCD device. The specifications this in the document are subject to change without notice. To download the full user’s manual visit us at: www.pcdlatam.com PCD and the PCD logo are registered trademarks of PCD,LLC. Other trademark are the property of their respective owners.
Charge for 6 hours before using.
Install SIM card / Memory card
- Remove the battery cover
- Remove the battery
- OPIace the SIM card and/or microSD in their slot and make sure that the gold contacts are facing down gold-plated contacts are facing down.
- Replace the battery and battery cover back into the device.
- Turn on the device.
Get know your new PCD device.
Connect your new PCD device to the computer using a USB cable. ****
Copy files from your computer to your new device.
Declaration of Conformity
This device complies with Part IS of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
CAUTION : Any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate
the equipment.
This equipment (FCC ID 2ALOOPL04) has been tested and found to comply with the limits for a Class B digital device, pursuant to Part IS of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device and its antenna(s) must not be co-located or operated in conjunction with any other antenna or transmitter.
Specific Absorption Rate (SAR) information
This product meets the government’s requirements for exposure to radio waves.
The guidelines are based on standards that were developed by independent
scientific organizations through periodic and thorough evaluation of
scientific studies. The standards include a substantial safety margin designed
to assure the safety of all persons regardless of age or health. FCC RF
Exposure Information and Statement the SAR limit of the USA (FCC) is 1.6 W/kg
averaged over one gram of tissue.
Device types: this product has also been tested against this SAR limit
This product was tested for typical body-worn operations with the back of the
phone kept 10mm from the body. To maintain compliance with FCC RF exposure
requirements, use accessories that maintain a 10mm separation distance between
the user’s body and the back of the product. The use of belt clips, holsters,
and similar accessories should not contain metallic components in its
assembly. The use of accessories that do not satisfy these requirements may
not comply with FCC RF exposure requirements and should be avoided
www.pcdlatam.com
7651 Southland Blvd. Orlando, FL 32809
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>