NovaCHARGE Retractor Bracket Instruction Manual
- June 12, 2024
- NovaCHARGE
Table of Contents
Retractor Bracket
Assembly Instructions
Retractor Bracket
Parts Included Please review the parts included to ensure you have all you need.
-
Stand the retractor next to the charger station to identify the needed height.
-
With the top of pedestal removed, measure down 6 inches and mark.
-
Using the bracket as a template, mark and drill two (2) 5/16” holes. Make sure the bracket is level during this step. Top of bracket should be lined up with mark from step 2.
-
Secure pedestal side of bracket with Bolts washers and nuts (A).
-
Tighten the nut on inside of charger pedestal.
-
Secure bolt (B) into the retractor. Bolt should go through the bracket, retractor collar, and snug up against the retractor itself.
Note: Please refer to the instructions inside the retractor box to complete the assembly.