GRILLED M10-050-100-VA Single Side Burner Unit Instruction Manual

M10-050-100-VA Single Side Burner Unit
Instruction Manual 2000630 (M10-050-100-AA.23)
Buffalo Kitchen Single Side Burner Unit
INSTRUCTION MANUAL
READ THE INSTRUCTIONS BEFORE USING THE APPLIANCE

M10-050-100-VA Single Side Burner Unit

WARNING INFORMATION
– Use Outdoors Only
– Read the instructions before using the appliance
– WARNING: accessible parts may be very hot. Keep young children away
– This appliance must be kept away from flammable materials during use
– Do not move the appliance during use
– Turn off the gas supply at the gas cylinder after use
– Do not modify the appliance
– Ensure there is adequate clearance away from flammable materials
– Do not allow children to operate this barbecue
– BBQ specifications can be found on the data label attached on the back of the trolley door
– Do not store or use petrol or other flammable vapors and liquids near the bbq
– Do not store empty or full spare gas cylinders under or near the bbq
– Keep the gas hose and any electrical cord away from hot surfaces
– Avoid unnecessary twisting of the gas hose
– Visually inspect hose prior to each use for cuts, cracks, excessive wear or other damage
– The hose must be replaced if damaged and when National Conditions require it
– Never light the bbq with the hood or lid closed
– Never lean over the cooking surface whilst lighting the bbg
– Use bbq tools with heat proof handles or good quality insulated oven mitts when operating bbg
– Never alter or modify the regulator or gas supply assembly

TESTING FOR LEAKS – DO THIS BEFORE USING YOUR BBQ
NOTE – DO NOT test for gas leaks with an open flame. If you smell gas, turn off at the source.
Before first use, at the beginning of each new season, or whenever a gas cylinder is changed, you must check for gas leaks. Do so by:
– Turn on the gas cylinder.
– Tum all gas valves on the bbq to the OFF position.
– Brush a soap solution of one part liquid detergent and one part water to all gas connections.
– The presence of bubbles indicates a leak. Tighten or repair as necessary.
–  Under no circumstances should a naked flame be used to check for leaks.
– If a gas odour is prsent and no leaks can be found, do not use the bbg. Turn the gas off at the source, disconnect the hose and immediately contact your bbq dealer or place of purchase for assistance.
Please note that this single side burner modular will be only used with BUFFALO 4 Burner gas BBQ (2000627) or BUFFALO 6 Burner gas BBQ (2000628) and should be assembled on the right hand side of the gas BBQ.

PARTS DIAGRAM

ASSEMBLY INSTRUCTIONS

Note: Step 11 and Step 12 are to remove the side burner shelf, side burner and bottle opener from the 4B/6B gas BBQ before assembling the single side burner modular to the gas BBQ. The side burner injectt along with the S/S flexible pipe will get into the single side burner modular through the holes on cabinet left side panel as shown here.
Note: After completing the installation of the injector for side burner, please run a leak testing for all the connection points. please refer to page 2 of this instructions for the detail of leak testing.
Do not use until you make sure there is no gas leakage.
The bottle opener on gas BBQ should be removed before the kitchen modular unit is assembled on the right side of the gas BBQ; and then, the bottle opener can be assembled on the cabinet right side panel of the modular unit as shown on diagram a. Using the sink modular as the example, the single side burner modular connects to the other modular by the cabinet connection panels inside cabinet.
Please note that you also need the brackets for the modular connection in the back of the appliances. Using the bracket for the connection of the single side burner modular and the gas BBQ.
Using the bracket for the connection of the single side burner modular and other modulars such as the sink modular.

List of spare parts

2 YEAR WARRANTY

‘YOUR APPLIANCE IS COVERED AGAINST DEFECTS FOR A PERIOD UP TO 2 YEAR FROM DATE OF PURCHASE FOR PARTS LABOUR AND REPAIR.
THIS WARRANTY EXCLUDES SURFACE RUST AND DAMAGE CAUSED BY ABUSE OR NEGLECT.
PLEASE THOUROUGHLY READ CONDTIONS OF THE WARRANTY
This warranty is given by Garth Australia Pty Ltd, Suite 14 981 North Road, Murrumbeena,  VIC 3163, AUSTRALIA at: www.garthsupport.com
free call number is 0800 357 050
Email address — info@garth.com.au
This warranty is provided in addition to other rights and remedies you may have under law: our goods come with guarantees which cannot be excluded under the Australian Consumer Law. You are entitled to replacement or refund for a major failure and to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. Any claim under this warranty must be made within 2 year of the date of purchase of the product. Proof of purchase must be presented.

CONDITIONS OF THE WARRANTY

– The product is warranted for a period of 2 year from date of purchase.
– Proof of purchase must be supplied when applying for warranty.
– The operating manual must be retained in a safe place.
– The appliance must be operated and maintained in accordance with the instructions supplied in the operating manual.
– Any repair does not extend the warranty period.
– Any parts other than original parts will void this warranty

INSTALLATION CONDITIONS

– All installations must conform to the applicable Gas, Electrical and Building standards as laid down by the local codes for state or region.
– If the appliance is changed to natural gas (if applicable), it must be converted and installed by a licensed gas fitter.
WHAT IS NOT COVERED IN THE WARRANTY
– Removal or re-installation costs. This warranty does not cover costs for transit, nor in home service.
– No liability will be accepted for loss or damage during transit.
– Lack of maintenance, abuse, neglect, misuse, accidental or improper installation of this appliance.
– Scratches, dents, corrosion or discoloration caused by heat, abrasive chemical cleaners or chipping of porcelain enamel parts.
– Rusting of cast iron plates, grills or burners.
– Cleaning and wear and tear – service calls of this nature are chargable
– Corrosion or damage caused by exposure to the elements such as insects, weather, hail or grease and fat fires.
– Commercial use of this appliance.
– Unauthorized repairs or modifications during the warranty period.
– Glass breakage due to misuse or overheating.
RECORD THE FOLLOWING INFORMATION IMMEDIATELY
Date of purchase……………………………..
Purchased from…………………………….
Location ……………………………………
Model name and number …………………..
Serial number …………………………
Receipt number…………………………….
Note: the serial number is located on both the outside of the packing carton and on the appliance data plate, either on the side of the bbq frame or inside the cabinet door.
ATTACH THE PURCHASE RECEIPT TO THIS WARRANTY SHEET

TECHNICAL ASSISTANCE

If you experience any technical issues with your BBQ, firstly review the operating manual and the troubleshooting sections or go to www.garthsupport.com or call: 0800 357 050.
FOR WARRANTY CLAIMS OR SPARE PARTS PLEASE GO TO www.garthsupport.com
To find your BBQ online go to the consumers section and select your country or region of purchase and follow the instructions.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>