MELEC ML-MRSLB-60-M MR Slim Batten Installation Guide
- June 4, 2024
- MELEC
Table of Contents
MELEC ML-MRSLB-60-M MR Slim Batten Installation Guide
Product information
M-Elec’s updated slim batten now integrates a snap on diffuser to make the fit off process that much faster and more flexible. Upgraded larger terminal blocks are utilised adding to the convenience. Rear entry and additional internal space simplifies cable routing. External CCT switch allows the user to pick the right lighting and change it depending on the conditions without opening the fitting. A 60cm and 120cm size will suit most applications. Comes standard with M-Elec’s 5 year warranty
TECHNICAL INFORMATION
Data subject to change, please visit our website for upto date specifications: melec.com.au
Total Power: | ML–MRSLB–60 ML-MRSLB-120-M |
---|
20W*
40W*
|
MAX Lumen Output:| WW 17001m
NW 1900lm
W 1800lm| WW 3400lm
NW 38001m
W 36001m
Colour Temp:| WW 3000K
NW 4000K
W 6000K
IP Rating:| IP20
Efficacy:| 90Im/w
CRI:| 80
Beam Angle:| 120°
Temp Range:| -20° to 40°C
Dimmable:| No
Power Supply:| Integrated driver
Average Life:| 36000hrs**
Operating current at 240V| 0 . 083A| 0 . 166A
Power Factor :| 0 9
Connection| PAl2 terminal block
Construction| Aluminium base + PMMA diffuser
Dimensions:| 600x 83.5×36.5mm| 1200×83.5×36.5mm
Weight| 0.4kg| 0.78kg
Warranty:| 5 years
- Total power consumed including driver
- Average life is calculated on expected average lifespan
INSTALLATION GUIDE
- Turn power off before commencing installation.
- Remove the diffuse by un-screwing the end cap (without CCT switch) and the pulling the diffuser up.
- Place the base against the wall or ceiling and use suitable fixings for your type of installation.
- Wire the fitting according to the terminal markings
- Reinstall the diffuse and the end cap
- Select the desired color output on the end cap containing the CCT switch.
- test according to all applicable standard and requirements.
PLEASE NOTE
MUST BE INSTALLED BY A LICENSED ELECTRICIAN
- Read instructions carefully before attempting to install the fitting. Retain this guide for future reference
- Disconnect power before installing or servicing
- This fitting is for outdoor use and should not be used in areas with limited ventilation or high ambient temperatures
- Do not extend low voltage cables from the output of power supply
- All components must not be mechanically stressed
- Be careful not to damage or destroy conductive paths on the circuit board
- Follow all relevant electrical and safety standards (including AS3000)
- Correct electrical polarity must be observed as the wrong polarity may destroy the product and is not covered under warranty
- Damage by corrosion will not be honoured as a material defect claim. It is the user’s responsibility to provide suitable protection against corrosive agents such as moisture, condensation and other harmful elements.
FREE ONSITE WARRANTY
EXCLUSIVE TO MEMBERS ONLY
FREE ONSITE WARRANTY FOR 3 YEARS INCLUDES PARTS & LABOUR
In conjunction with your standard product warranty
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>