fri-jado BS10 i Auto Clean Rotisserie Instruction Manual
- June 12, 2024
- fri-jado
Table of Contents
fri-jado BS10 i Auto Clean Rotisserie
- The below 9192202s board is no longer deliverable. This because some components became obsolete
- The below 9192400 board will replace it
- Old boards have spade terminals
- New boards have multi pole sockets
The kit comes with:
- → An interface board 9192402 to convert the output wiring.
- → A bracket with wiring to convert the input wiring.
- → Mounting material.
The principle
Inputs are signals like switches and sensors. Outputs are power consumers like
contactors, motors, lamps.
Preparation
Note that the assembly of boards has one spacer mounted, with the top, cut
off. Check if the connectors are completely pushed into each other.
Conversion of the ACR
- Disconnect the mains power.
- Remove the service panel.
- Unscrew the screw and turn the I/O board outwards.
- Disconnect all wires and number them with the “X” numbers.
Convert the inputs bracket
- Push down the barb with a small screw driver and pull out the red wire from J10.
- Push the wire in the empty position of J16 and check if it is fixed. Adjust the barb if necessary.
- Rename J10 into J16. Rename X26 into X34. Cross out X 27.
Connect the mains power and upgrade the software, if applicable. Check all inputs and outputs by means of the I/O test facility in the service parameters. If everything ok, then remount the side panel.
Overview of board terminals
Leave this sheet in the oven, next to the electric diagrams for future trouble shooting.
Electrical diagram of the new board assembly
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>