hama 00220886 Wall Mount for Sonos One or One SL Instruction Manual
- June 12, 2024
- Hama
Table of Contents
hama 00220886 Wall Mount for Sonos One or One SL
Package Contents
- Speaker Wall Mount
- Hook-and-loop patches
- Installation kit
- These operating instructions
Note
Please check that the installation kit is complete before installing the
bracket and ensure that none of the parts are faulty or damaged.
Safety Notes
Warning
- Please note that the supplied wall plugs are for use with concrete brick and solid brick walls only.
- If the wall on which the bracket is to be mounted is made of different material types and construction types to those specified, purchase suitable mounting materials from a specialised dealer.
- If in doubt, have this product mounted by a qualified technician – do not attempt to mount it yourself!
- Ensure that electrical cables are not crushed or damaged during installation.
- Do not mount the product above locations where persons might linger.
- Once you have mounted the product and the attached load, check that they are sufficiently secure and safe to use.
- You should repeat this check at regular intervals (at least every three months).
- When doing so, ensure that the product does not exceed its maximum permitted carrying capacity and that no load exceeding the maximum permitted dimensions is attached.
- Make sure that the product is loaded symmetrically.
- Maintain the necessary safety clearance around the attached load (depending on the model).
- In the event of damage to the product, remove the attached load and stop using the product.
Intended use and specifications
- The product is intended for use only as a mount for the Sonos One/One SL.
- The product is for domestic use
- The product is intended for indoor use only.
- Only use the product for the intended purpose.
Installation requirements and installation
- Observe the other warnings and safety instructions.
- Proceed step-for-step in accordance with the illustrated installation instructions (Fig. 1 ff.).
- The included adhesive patches are ideal for safely securing the terminal device.
First attach the adhesive patches to the bottom of the terminal device. Then remove the protective film and place the terminal device centred on the mount.
Setting and maintenance
Check that the holder is secure and safe to use at regular intervals (at least
every three months).
Only clean with water or standard household cleaners.
Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for damage
resulting from improper installation/mounting, improper use of the product or
from failure to observe the operating instructions and/or safety notes.
Service and Support
Please contact Hama Product Consulting if you have any questions about this
product.
Hotline: +49 9091 502-0 (German/English)
Further support information can be found here:
www.hama.com
All listed brands are trademarks of the corresponding companies. Errors and omissions excepted, and subject to technical changes. Our general terms of delivery and payment are applied.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>