SEALEY ACL3.V5 Aluminium Extension Combination Ladders Instruction Manual

SEALEY ACL3.V5 Aluminium Extension Combination Ladders

Product Information

• Product Name: Aluminium Extension Combination Ladders EN 131
• Model Numbers: ACL3.V5, ACL307.V3, ACL312.V4
• Manufacturer: Sealey

This product is manufactured to a high standard and is designed to provide years of trouble-free performance when used according to the provided instructions and properly maintained.

Please read these instructions carefully and follow the safe operational requirements, warnings, and cautions. Incorrect use of the product may result in damage or personal injury and will invalidate the warranty.

Product Usage Instructions

Safety:

• Inspect the ladder after delivery to ensure it is in good condition.
• Before every use, visually check the ladder for any damage and ensure it is safe to use.
• Do not use a damaged ladder.
• Observe the maximum total load of 150kg.
• Do not use the ladder on an unlevel or unfirm base.
• Do not overreach while using the ladder.
• Do not erect the ladder on contaminated ground.
• Observe the maximum number of users allowed on the ladder.
• Always face the ladder while ascending or descending.
• Maintain a secure grip on the ladder when climbing or working from it. Take additional safety precautions if necessary.
• Avoid tasks that impose a sideways load on the ladder.
• Do not carry heavy or difficult-to-handle equipment while using the ladder.
• Wear suitable footwear when climbing the ladder.
• Do not use the ladder if you are not physically fit or under the influence of substances that could impair your ability to use it safely.
• Take regular breaks when using the ladder for long periods to prevent fatigue.
• Prevent ladder damage during transportation by fastening it securely and placing it in a suitable position.
• Ensure the ladder is suitable for the task at hand.
• Do not use the ladder if it is contaminated with wet paint, mud, oil, or snow.
• Avoid using the ladder in adverse weather conditions, such as strong wind.
• For professional use, conduct a risk assessment in accordance with the legislation of your country.
• Consider the risk of collision with the ladder from pedestrians, vehicles, or doors when positioning it. Secure doors and windows in the work area if possible.

Electricity Hazard:

• Identify any electrical risks in the work area and do not use the ladder where electrical risks occur.
• Use non-conductive ladders for unavoidable live electrical work.

Leaning Ladders:

• Leaning ladders with rungs should be used at the correct angle.

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance.

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

SAFETY

GENERAL SAFETY REQUIREMENTS

• WARNING! Risk of falling from the ladder.
• Refer to instructions.
• Inspect the ladder after delivery.
• Before every use visually check the ladder is not damaged and is safe to use.
• DO NOT use a damaged ladder.
• Observe maximum total load 150kg.
• DO NOT use the ladder on a unlevel or unfirm base.
• DO NOT over reach.
• DO NOT erect ladder on contaminated ground.
• Observe maximum number of users.
• DO NOT ascend or descend unless you are facing the ladder.
• Keep a secure grip on the ladder when ascending or descending. Maintain a handhold whilst working from a ladder or take additional safety precautions if you cannot.
• Avoid work that imposes a sideways load on ladders, such as side on drilling through solid materials.
• DO NOT carry equipment which is heavy or difficult to handle whilst using a ladder.
• DO NOT wear unsuitable footwear when climbing a ladder.
• DO NOT use a ladder if you are not fit enough. Certain medical conditions or medication, alcohol or drug abuse could make ladder use unsafe.
• DO NOT spend long periods on a ladder without regular breaks (tiredness is a risk).
• Prevent damage of the ladder when transporting e.g. by fastening and, ensure they suitably placed to prevent damage.
• Ensure the ladder is suitable for the task.
• DO NOT use the ladder if contaminated, e.g. with wet paint, mud, oil or snow.
• DO NOT use the ladder outside in adverse weather conditions, such as strong wind.
• For professional use a risk assessment shall be carried out respecting the legislation in the country of use.
• When positioning the ladder take into account risk of collision with the ladder e.g. from pedestrians, vehicles or doors. Secure doors (not fire exits) and windows where possible in the work area.

WARNING! ELECTRICITY HAZARD

• Identify any electrical risks in the work area, such as overhead lines or other exposed electrical equipment and DO NOT use the ladder where electrical risks occur.
• Use non-conductive ladders for unavoidable live electrical work.
• DO NOT use the ladder as a bridge.
• DO NOT modify the ladder design.
• DO NOT move a ladder while standing on it.
• For outdoor use caution to the wind.
• If a ladder is delivered with stabiliser bars these bars should be fixed by the user before the first use, see assembly section overleaf.
• Check if ladder is suitable for domestic/professional use.

SAFETY REQUIREMENTS FOR LEANING LADDERS

• Leaning ladders with rungs shall be used at the correct angle.
• Only use ladder in the direction as indicated, only if necessary due to the design of the ladder.
• Ladders used for access to a higher level shall be extended at least 1 metre above the landing point and secured, if necessary.
• DO NOT lean the ladder against unsuitable surfaces.
• Ladder must never be moved from the top.
• DO NOT stand on the top three steps/rungs of a leaning ladder.

SAFETY REQUIREMENTS FOR STANDING LADDERS

• DO NOT step off the side of a standing ladder onto another surface.
• Open the ladder fully before use.
• Use the ladder with restraint devices engaged only.
• Standing ladders shall not be used as a leaning ladder unless it is designed to do so.
• DO NOT stand on the top two steps/rungs of a standing ladder without a platform and a hand/knee rail.

SAFETY REQUIREMENTS FOR COMBINATION/EXTENDING LADDERS

• DO NOT climb above the rung or tread recommended of the combination ladder used in a standing position, with extending ladder at the top. The minimum requirement shall always be: DO NOT climb above the top four steps/rungs.
• Locking devices shall be checked and be fully secured before use if not operated automatically
• The loose end of the rope shall be tied to the ladder (only if necessary due to design of rhe ladder).

INTRODUCTION

Aluminium extension ladders manufactured to EN 131 standards. Ideal for the tradesman, this ladder can be used as a three section or two section extension and as a single ladder, which is ideal for two-man use. Can be used as a step and extension step ladder where stability and height are needed. Compact size for easy handling and storage.

SPECIFICATION

• Model no ………………………………………………………….ACL3.V5
• Maximum Capacity :……………………………………………….150kg
• Maximum Extension :…………………….3.60m when in ‘A’ frame
• Maximum Reach :……………………………………………………6.5m
• Minimum Height :…………………………………………………..2.47m
• Tread Count :………………………………………………………….3 x 9
• Model no ………………………………………………………ACL307.V3
• Maximum Capacity :……………………………………………….150kg
• Maximum Extension :…………………….2.84m when in ‘A’ frame
• Maximum Reach :………………………………………………………5m
• Minimum Height :…………………………………………………..1.93m
• Tread Count :………………………………………………………….3 x 7
• Model no ………………………………………………………ACL312.V4
• Maximum Capacity :……………………………………………….150kg
• Maximum Extension :……………………………………………..7.59m
• Maximum Reach :………………………………………………….8.49m
• Minimum Height :…………………………………………………….3.3m
• Tread Count :………………………………………………………..3 x 12

ASSEMBLY

FIT FOOT refer to fig.1
Note: Foot must always be fitted in use.

1. Pull plastic feet from bottom of both ladder legs.
2. Place foot in cut out section of both feet and re-insert into legs.
3. Secure through leg and plastic feet with screw , nut and washer, of both legs.

MAINTENANCE

1. Keep ladder clean. Repairs must be performed by suitably trained operatives only
2. Store out of direct sunlight

ENVIRONMENT PROTECTION

Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids according to local regulations.

Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice. Please note that other versions of this product are available. If you require documentation for alternative versions, please email or call our technical team on technical@sealey.co.uk or 01284 757505.

Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.

Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR

01284 757500
01284 703534
sales@sealey.co.uk
www.sealey.co.uk

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>