EKVIP 024723 Wall Lamp Instruction Manual

EKVIP 024723 Wall Lamp

IMPORTANT INFORMATION

Jula AB reserves the right to make changes to the product. Jula AB claims copyright on this documentation. It is not allowed to modify or alter this documentation in any way and the manual shall be printed and used as it is in relation to the product. For the latest version of operating instructions, refer to the Jula website.

SAFETY INSTRUCTIONS

Read these instructions carefully before use.

• Always switch off the power supply before installation, connection and maintenance.
• The electrical installation must comply with local regulations. Consult an authorised electrician if in doubt.
• Always follow the electrical specifications on the product labelling.
• The light source gets hot when the product is switched on. Do not touch the light source until it has cooled.
• A damaged glass cover must be replaced immediately. Do not use the product if the glass cover is damaged.
• Do not use the product without the glass cover.
• Do not look into the light without wearing eye protection – risk of dazzling and/or eye damage.
• Only connect the product to a correctly earthed power point.
• The cord should be a the 3G type with a cross-sectional area of at least 1 mm2 .
• Do not use the product if it is damaged or not working properly, or if the power cord or plug are damaged. If the power cord or plug are damaged they must be replaced by an authorised service center to ensure safe use. Contact the retailer.
• Never modify the product, this could result in serious personal injury and/or material damage.

ELECTRICAL SAFETY!

New installations and extensions to existing systems should always be carried out by an authorised electrician. If you have the necessary experience and knowledge (otherwise contact an electrician), you can replace power switches and wall sockets, fit plugs, extension cords and light sockets. Incorrect installation can result in fatal injury and the risk of fire.

SYMBOLS

| Read the instructions.
---|---
| Approved in accordance with the relevant directives.
| Recycle discarded product in accordance with local regulations.

TECHNICAL DATA

Rated voltage 230 V ~ 50 Hz
Max permitted output of light source 100 W
Socket E27
Protection rating IP44
Size 30 x 26 x 32.6 cm

DESCRIPTION

For outdoor use with classic lamp and globe made of glass. Retaining screws included. Light source sold separately.

INSTALLATION

1. Remove the cover and diffuser and insert a light source (max 100 W) in the socket. Replace the diffuser and cover.
2. Put both hex screws and the rubber seal in the mounting plate.
3. Use the mounting plate as a template to mark out the position of the holes. Check that there are no concealed wire or tubes in the wall where the holes are to be drilled. Use suitable expander plugs in the holes if necessary.
4. Stamp holes in the rubber seal for the mounting plate with a sharp tool. Insert the power cord through the rubber seal in the mounting plate.
5. Screw the mounting plate on the wall with the supplied screws and washers.
6. Connect the power cord to the terminal block: brown wire to brown wire on lamp (L = phase), blue wire to blue wire on lamp (N = neutral), green/yellow wire to green/yellow wire on lamp (earth).
7. Put the terminal block in the plastic panel.
8. Fasten the lamp on the wall bracket with nu

**FIG. 1-15**

REPLACING THE LIGHT SOURCE

1. Pull out the plug.
2. Remove the diffuser.
3. Do not touch the light source with your fingers.
4. Allow the light source to cool and then unscrew it.
5. Carefully screw in a new light source.
6. Replace the diffuser before switching on the lamp

024723

References

• Jula – products for home and garden

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>