JAN-FAN JF-12F 18 Inch Wall Mounted Fan Instructions
- June 12, 2024
- JAN-FAN
Table of Contents
MODEL #JF-12F / 18F
12″ or 18″ FLOOR/BENCH AIR CIRCULATOR
COMPLETE WITH WALL/CEILING BRACKET
IMPORTANT : READ AND SAVE THESE INSTRUCTIONS
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN
THIS PRODUCT.
FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR
PROPERT Y DAMAGE!
It Is important that the following safety procautions be followed when using this product:
- ALWAYS unplug unit for cleaning or maintenance.
- ALWAYS unplug when moving unit from one location to the next.
- ALWAYS only plug the three-prong plug into a matching three-conductor grounded wall outlet.
- DO NOT use the three-prong plug with a two-prong adapter.
- DO NOT place foreign objects through guards into blade.
- DO NOT allow unit to become wet or damp.
WARNING : To avoid risk of fire or electrical shock. DO NOT use this fan with any solid state speed control device such as a dimmer switch.
OPERATING INSTRUCTIONS
This product is intended for indoor use only. Simply plug the fan into a 115 volt, 60 HZ, grounded wall outlet and select one of three speeds.
WALL/CEILING INSTALLATION
WARNING: To keep fan from falling. from any cause, in an overhead mount
application, it is strongly recommended that a Safety Cable be installed.
Safety Cable must be fed through the handle on the rear guard, then clamp or
otherwise fasten to a secure building joist, beam or other support. Take up
all excess slack in the Cable, making sure there is no part of the Cable that
may interfere with the Blade. For optional Safety Cable Kit order Model #JF-
SCK.
Remove fan stand adjustment knobs and remove floor stand from the fan. Install
yoke bracket included in carton by reversing this procedure.
- WOOD STRUCTURES: Locate the wall or ceilling stud at the desired Fan location. Attach the Fan to the stud using a 3/8″ diameter x 2″ long Lag Screw (Not Supplied). (Figure 1)
- STEEL STRUCTURES: Attach the Fan using a 3/8″ bolt of the appropriate length, with a Flat Washer, Lock Washer and a 3/8″ Nut (Not Supplied).
- MASONARY STRUCTURES: Attach Fan using a 3/8″ Lag Screw, with a Lag Shield of appropriate length (Not Supplied). (Figure 1)
NOTE : IN ALL CASES, IF SMOOTH ROTATION IS DESIRED, IT IS RECOMMENDED THAT A FLAT WASHER BE PLACED ON BOTH SIDES OF THE FAN YOKE BRACKET. (Figure 1)
CLEANING/ MAINTENANCE INSTRUCTIONS
The motor bearings are lubricated at the factory and should not require any
additional lubrication.
The propeller blades must be cleaned periodically to prevent accumulated dirt
from causing imbalance. Open the four quick clips located around the perimeter
of the guard and remove the front guard. Use a mild detergent to clean the
blade and guards. Avoid allowing the cleaner to come in contact with the motor
winding or bearing. Replace the front guard and securely close the 4 quick
clips. Allow fan to completely dry before use.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>