Pioneer BRK-FLR-GS-2P Floor Stand Ground Mounting Bracket Instruction Manual

Pioneer BRK-FLR-GS-2P Floor Stand Ground Mounting Bracket

Product Information

The product is a bracket stand designed to mount a condenser unit. It consists of a main bracket frame, four bracket stand legs, two horizontal cross bar legs, and vibration absorbers. The unit is securely fastened using nuts, washers, bolts, and square nuts.

Product Usage Instructions

1. Use the wrench to fix the foot plate to the vertical leg using 1x nut and 1x washer. Repeat this step three more times to assemble all four bracket stand legs.
2. Decide which of the 5 slots the primary frame will be fixed to for each leg. This determines the height at which the unit will rest once fully assembled.
3. Fix the 4 assembled bracket legs to each of the 4 corners of the main bracket frame. Use the wrench and 2x M8 nuts+ washers to securely fasten them into place.
4. Slide the small square nuts through all 4 slots on the 2 horizontal cross bar legs.
5. Slide the vibration absorbers over each of the square nuts from Step 5.
6. Place the horizontal legs onto the frame and fasten them using 4x M8*16 bolt+ nut/washer. Do not tighten fully until Step 8 is completed.
7. Measure and match the distance between the legs to that of the unit’s mounting feet.
8. Place the condenser unit onto the horizontal legs and align the 4 feet and pad holes.
9. Use 4x M8-30 bolts+nut/washer to securely fasten the unit to the assembled bracket.

The system is now mounted to the bracket. There are feet holes available for mounting to a pad or slab.

Parts

The bracket set consists of the following components:

• Ix Primary Bracket Frame
• 4x Plate-Shaped Feet
• 4x Metal Vertical Legs
• 2x Horizontal Legs
• 4x Vibration Absorbers
• 4x Square Slot Nuts
• 4× M816 Bolts
• 4x M830 Bolts+ Washers
• 16x M8 Nuts+ Washers*

*Found within the hardware bag

Assembly Procedure

• Step 1: Use the wrench to fix the foot plate to the vertical leg using 1x nut and 1x washer

• Step 2: Repeat Step 1 three times so that all four of the bracket stand legs are assembled

• Step 3: Decide which of the 5 slots the primary frame will be fixed to, for each leg

Basically this will determine the height the unit will end up resting at once fully assembled.

• Step 4: Fix the 4 assembled bracket legs to each of the 4 corners of the main bracket frame

Use the wrench and 2x M8 nuts + washers to securely fasten into place, for each of the 4 corners

• Step 5: Slide the small square nuts through all 4 slots on the 2 horizontal cross bar legs.

• Step 6: Slide the vibration absorbers over each of the square nuts from Step 5 as shown below.

• Step 7: Place the horizontal legs onto the frame and fasten using 4x M8*16 bolt + nut/washer.

(Don’t tighten fully until Step 8 is completed)

• Step 8: Measure and match the distance between the legs to that of the unit’s mounting feet.

• Step 9: Place the condenser unit onto the horizontal legs, and align the 4 feet and pad holes.

• Step 10: Use 4x M8-30 bolts + nut/washer to securely fasten the unit to the assembled bracket.

The system is now mounted to the bracket. Feet holes are available for mounting to a pad/slab.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>