MORSE 4560B-P Rim Clamp Kit Instruction Manual
- June 4, 2024
- MORSE
Table of Contents
MORSE 4560B-P Rim Clamp Kit
INSTALLATION INSTRUCTIONS
- Position Rim Clamp Assembly on INSIDE of drum holder bracket (item 1) with holes aligned
- Bolt in place using 2 bolts (item 2) and 2 washers (item 3)
WARNING: This product can expose you to chemicals including barium sulfate, cobalt, titanium dioxide, and 2-methylimidazole, which are known to the State of California to cause cancer, and bisphenol-A, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
Operator’s Manual for Morse Rim Clamp Assembly Kit # 4560B-P Serial Number 0821 to ____ (MMYY)
BEFORE OPERATING RIM CLAMP
Set Correct Rim Clamp Position for 55-Gallon OR for 30-Gallon Drum Insert pin through correct holes to set Top Rim Clamp to position for ONE of the following drum sizes:
- 55-gallon (210 liter) size drum
- 30-gallon (114 liter) size drum
OPERATING INSTRUCTIONS
Steps to Secure Drum
STEP 1.
Tighten cinch chain or web strap around drum just enough to hold drum with
bottom jaw of Top Rim Clamp positioned under top rim of drum. Swing bottom jaw
into position against drum sidewall to engage directly beneath drum top rim.
STEP 2.
Swing top hook over top rim of drum and turn hand wheel clockwise until
SECURELY clamped over drum top rim.
STEP 3.
Securely tighten cinch chain or web strap around drum.
STEP 4.
IMPORTANT: Lift Drum SLIGHTLY… Then ensure:
- Bottom jaw is engaged under drum top rim
- TIGHTEN Top jaw to ensure it grips drum top rim
Steps to Release Drum
- Lower drum to floor in upright position
- Release cinch chain or web strap from around drum
- Open Top Rim Clamp by turning knob counter clockwise
- Disengage hook from drum top rim
Assembly Kit
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>