Primacol Modern Stone Pattern Book Instructions
- June 12, 2024
- PRIMACOL
Table of Contents
Instruction
Modern Stone
Modern Stone Pattern Book
NOTE
Always test the product before use on the main surface. The effect obtained
depends on many factors, such as substrate preparation, tools used,
application technique. The manufacturer is not responsible for improper use of
the product.
Tools should be washed frequently during work to avoid scratches on the
decorated surface caused by the residue of the dried product.
It is recommended to decorate the surface with products from one production
batch. Otherwise, the contents of all packages must be mixed together in one
container.
The product should be stored in a tightly closed original container at 5 – 25
°C and out of the reach of children. Do not expose it to sunlight. Protect
from freezing.
SUBSTRATE PREPARATION
The substrate should be clean, degreased, even, stable and uncracked. Fresh
cement and lime-cement plasters should be seasoned for at least 4 weeks.
Paint the surface with Decobase paint. It will create a base coat similar to
the effect’s colour, reduce the consumption of Modern Stone and ensure the
best possible final result. When dry, sand the wall gently with fine sandpaper
and dust it off afterwards.
Highly absorbent or not equally absorbent surfaces should be primed with a
suitable primer before applying Decobase. We recommend our PRIMACOL®
DECORATIVE primer.
APPLICATION
After opening the Modern Stone bucket, stir the contents thoroughly,
preferably with a mechanical agitator at slow speed or alternatively by hand.
Start applying the paste from the top corner of the wall and move diagonally,
extending the decorated surface.
Apply the product with a paint roller, spreading it in different directions.
Then smooth the entire surface with a wide spatula to give the decoration a
pattern.
Work on an area of about 0.5 m² at a time. Join the decorated areas together
by working “wet on wet”. The joints between each area will create an
additional effect, so plan their placement carefully to obtain nice
transitions.
Once the whole wall is finished, leave it to dry for about 12 hours.
After this time, using a wide spatula, gently cut away any protruding parts,
then sand them with fine sandpaper and dust off the wall.
Apply a second layer in the same way as the first starting also from the top
of the wall, but from the opposite corner.
Once the painting is complete, leave the wall to dry again for about 12 hours.
After this time, cut off the protruding parts, sand with fine sandpaper and
dust off the wall. Then, carefully polish the surface with a clean spatula to
create an effect of depth.
As the last step, protect the wall with PRIMACOL® DECORATIVE varnish by
spreading it in different directions with a roller and leave it for at least
12 hours until completely dry.
Watch the instructional
videohttp://filmy.unicell.pl/?link=primacol_modernstone
Share your project and inspire others!
@primacol_com | #modernstoneprimacol
primacol.com
shop@primacol.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>