G-Homa R1001 Indoor Remote Control Plug 2 Transmitters 5 Receivers User Manual

G-Homa R1001 Indoor Remote Control Plug 2 Transmitters 5 Receivers

Product Information

Specifications:

• Input Voltage: 125V~60Hz
• Maximum Current: 15A
• Maximum Power: 1/2HP, 1875W (Resistive), 1250W (Tungsten)
• Remote Transmitter Battery: DC CR2032, 3V battery 1pc
• Transmission Range: Up to 100ft
• Frequency: 433.92MHz

Important Safety Guidelines:

• DO NOT ingest the coin/button cell battery. It can cause severe internal burns and even death. Keep batteries away from children.
• If the battery compartment does not close securely, stop using the product and keep it away from children.
• If batteries are swallowed or placed inside any part of the body, seek immediate medical attention.
• Appliances connected to the remote control socket must not exceed the voltage and current ratings as specified in the specifications.
• Operation is subject to the following conditions:
  • This appliance may not cause harmful interference,
  • This appliance must accept any interference received, including interference that may cause undesired operation.
• For indoor use and storage only.
• A low transmitter battery may lower the distance between the transmitter and the receiver.

Product Usage Instructions

Step A: Remote Battery Installation

1. Locate the battery compartment on the back of the remote.
2. Push down and away to slide the compartment cover open.
3. Remove the plastic battery tab from the battery compartment.
4. Slide the compartment cover back on the remote and click it securely into place.

Step B: Receiver Installation

1. Plug the receiver into a standard AC electrical wall socket.
2. Plug the appliance into the receiver outlet.

Step C: Power Control

• To turn all outlets ON or OFF at the same time, press the power button located at the top right corner of the remote. The side indicator light button will also flash ON or OFF accordingly.
• To manually turn ON or OFF one outlet, press the ON or OFF button on the remote control for numbers 1-5.

Frequently Asked Questions:

Q: How far is the transmission range?
The transmission range is up to 100ft.

Q: How do I replace the battery in the hand-held remote unit?
If operation of the receiver units becomes erratic, follow these steps:

1. Remove the battery compartment cover on the back of the remote.
2. Press the tray release button on the back of the remote to remove the depleted battery and discard it according to local ordinances.
3. Install a new battery correctly.
4. Replace the battery compartment cover.
5. Test the remote control by using it to control the indoor remote control outlets.

Q: What are the grounding instructions for the plug?
In the event of malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. The plug must be connected to a cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.

Indoor Remote Control Plug
2 transmitters + 5 receivers

Important Safety Guidelines

SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Definitions: Safety Alert Symbols and Words
This instruction manual uses the following safety alert symbols and words to alert you to hazardous situations and your risk of personal injury or property damage.

• DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
• WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
• CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury. (Used without word) Indicates a safety related message.
• NOTICE: Indicates a practice not related to personal injury which, if not avoided, may result in property damage.
• WARNING: PLEASE READ THIS INSTRUCTION MANUAL THOROUGHLY AND COMPLETELY BEFORE INSTALLATION & USE. FAILURE TO DO SO COULD CAUSE DAMAGE TO PROPERTY, SERIOUS INJURY OR DEATH, AND VOID YOUR WARRANTY.
• WARNING: Cancer and Reproductive Harm- www.P65Warnings.ca.gov .
• For California residents

indoor Remote Control Plug

• WARNING: Danger of explosion if battery is incorrectly replaced. When replacing battery, replace it with the same or equivalent type CR2032. Observe correct polarity (+ and –) when replacing batteries. Do not store or carry batteries so that metal objects can contact exposed battery terminals.
• DANGER: DO NOT INGEST BATTERY; CHEMICAL BURN HAZARD. This product contains a coin/button cell battery. If the coin/button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death.
• Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product and keep it away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.

1. Step A : Locate the battery compartment on the back of the remote. Push down and away to slide the compartment cover o”.

2. Step B: Remove the plastic battery tab from the battery compartment in the back of the remote control to activate the pre-installed battery.

3. Step C: Slide the compartment cover on the remote and click securely into place. Your remote is now ready to use.

4. Plug the receiver into a standard AC electrical wall socket. Plug the appliance into the receiver outlet.

5. To turn all outlets ON or OFF at the same time, press the power button located at the top right corner of the remote. Meanwhile, the side indicator light button will also flash ON or OFF. To manually turn ON or OFF one outlet, press the ON or OFF button on the remote control for numbers 1-5.

Specifications

• 125V~60Hz, 15A, 1/2HP,
• 1875W(Resistive), 1250W(Tungsten), 433.92MHz
• Remote transmitter battery: DC CR2032, 3V battery 1pc
• Transmission range: up to 100ft

Remote Battery Replacement

If operation of the receiver units becomes erratic, it may be necessary to replace the battery in the hand-held remote unit. To do this, first remove the battery compartment cover. Press the tray release button on the back of the remote. Next, remove the depleted battery and discard according to local ordinances. Be sure to correctly install the new battery. Replace battery compartment cover and test by using it to control the indoor remote control outlets.

CAUTION :

1. Appliances to be connected to the remote control socket MUST NOT exceed the voltage and current ratings as in “Specifications”.
2. Operation is subject to the following two conditions:
3. This appliance may not cause harmful interference,
4. This appliance must accept any interference received, including interference that may cause undesired operation.
5. Only for indoor use and storage.
6. Low transmitter battery may lower the distance between the transmitter and the receiver.

GROUNDING INSTRUCTIONS

• In the event of malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. The plug must be connected to a cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.
• DANGER: Improper connection of the equipment grounding conductor can result in a risk of electric shock. The conductor with insulation having an outer surface that is green with or without yellow stripes is the equipment grounding conductor. If repair or replacement of the cord or plug is necessary, do not connect the equipment-ground-ing conductor to a live terminal. Check with a qualified electrician or service person if the grounding instructions are not completely understood, or if in doubt as to whether the plug is properly grounded. Do not modify the plug connected to the plug – if it will not fit the outlet, have a proper outlet installed by a qualified electrician.
• FOR GROUNDED, CORD-CONNECTED PLUG RATED LESS THAN 15A AND INTENDED FOR USE ON A NOMINAL 125V SUPPLY CIRCUIT The plug is for use on a nominal 125V circuit, and should be connected to a grounding outlet that looks like that illustrated in sketch a. A temporary adaptor, which looks like the adaptor illustrated in sketch b, may be used to connect this plug to a 2-pole receptacle as shown in sketch b if a properly grounded outlet is not available. The temporary adaptor should be used only until a properly grounded outlet can be installed by a qualified electrician. The green colored rigid ear, lug, and the like, extending from the adaptor must be connected to a permanent ground such as a properly grounded outlet box cover. Whenever the adaptor is used, it must be held in place by the metal screw.
• NOTE: IN CANADA, THE USE OF A TEMPORARY ADAPTOR IS NOT PERMITTED BY THE CANADIAN ELECTRICAL CODE. Ensure that the timer is connected to an outlet having the same configuration as the plug.

1 YEAR LIMITED WARRANTY

• IMPORTANT: Proof of Purchase is required to obtain warranty service.
• G-Homa warrants to the original owner that our products will be free from defect in workmanship and material for a period of ONE YEAR from the date of purchase. Should any unit(s) prove to be defective during this period, G-Homa will be responsible for replacement of the defective unit(s) only. G-Homa is not responsible for labor charges or any incidental or consequential expenses.
• Not Covered – Batteries are not covered by this warranty. Repair service, adjustment and calibration due to misuse, abuse or negligence are not covered by this warranty. Unauthorized service or modification to this product or of any furnished components will void this warranty in its entirety.
• This warranty does not include reimbursement for inconvenience, installation, set-up time, loss of use, postage, unauthorized service, or other products used in conjunction with G-Homa products.

Copyright C 2021 G-Homa

• G-Homa and the G-Homa Logo are trademarks of EverFlourish Global Development Co., Ltd.
• or an a liate thereof and are used under license.
• www.g-homa.com
• E-mail: support@g-homa.com

References

• ghoma – G-Homa
• ghoma – G-Homa
• P65Warnings.ca.gov
• p65warnings.ca.gov/

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>