LIGHT n Carry LNC1841 COB LED Rechargeable Work Light User Manual

: June 12, 2024
: LIGHT n Carry

Table of Contents

LNC1841 COB LED Rechargeable Work Light
IMPORTANT SAFETY INSTRUCTIONS
PERSONAL SAFETY PRECAUTIONS
FEATURES
CHARGING
OPERATING INSTRUCTIONS
MAINTENANCE INSTRUCTIONS
STORAGE INSTRUCTIONS
REPLACEMENT PARTS
LIMITED WARRANTY
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

COB LED Rechargeable Work Light
Operator’s Manual
Model No. LNC1841

LNC1841 COB LED Rechargeable Work Light

WARNING
Failure to follow instructions may cause damage or explosion, always shield eyes. Read entire instruction manual before use.
WARNING: This product can expose you to chemicals, including Vinyl- Chloride, Styrene and Acrylonitrile, which are known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov.
PLEASE SAVE THIS OWNERS MANUAL AND READ BEFORE EACH USE.
This manual will explain how to use the work light safely and effectively. Please read and follow these instructions and precautions carefully. In the rare event that your work light contains a damaged or missing item, does not perform as specified, or requires warranty service, please call Technical Service at 913-310-1050. Save your purchase receipt, it is required for warranty service.
This unit has a sealed lithium battery that should be kept at full charge. Recharge when first received, immediately after each use, and every three months if not used. Failure to perform maintenance charges may cause the battery life to be reduced greatly.
WARNING

| Read these instructions completely before using the Light-N-Carry and save them for future reference.
---|---
| Fire Risk – do not disassemble, crush, puncture or ignite internal battery.
| Always wear eye protection, appropriate protective clothing and other safety equipment when working on vehicles or other equipment.

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS – This manual contains important safety and operating instructions for Model No.
LNC1841. Read, understand and follow all instructions, cautions and warnings listed in this manual. Failure to follow all instructions could result in personal injury, injury to others and property damage.
IMPORTANT! – Charge work light immediately after purchase, after each use, and at least every 3 months when not in use.
DO NOT turn on the work light while it is being charged.
DO NOT handle or move the work light while it is being charged.
DO NOT look directly into the light or shine the light directly into the eyes of any person or animal.
DO NOT allow children to use the work light.
DO NOT operate the work light if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a qualified service person.
DO NOT allow the unit’s battery to stay in a discharged state for long periods of time. This has a detrimental effect on battery life.
AC CHARGER FOR INDOOR USE ONLY. DO NOT expose the charger to water or use in damp conditions.
WARNING: Do not use any other charger except the one provided to charge the work light. Use of a charger not supplied by the manufacturer may result in a risk of fire, injury to persons and/or damage to property.
DO NOT use the work light with a charger which has a damaged cord or plug. Replace the cord or plug immediately.
To reduce the risk of damage to the charger plug, pull by the plug, rather than the cord, when disconnecting the charger.
DO NOT use the provided charger to charge or power any other electrical item.

PERSONAL SAFETY PRECAUTIONS

WARNING: To reduce risk of fire or burns, do not disassemble, crush or puncture internal battery, short external contacts, or dispose of in fire or water.
WARNING: Avoid direct exposure of LED light to eyes.
Do not shine into the eyes of people or animals. Keep away from children.
DO NOT disassemble the work light; take it to a qualified service person when service or repair is required. Incorrect reassembly may result in a risk of fire.
DO NOT expose to temperatures above 140˚F (60˚C).
Recycle or dispose of the used battery as required by local regulations.

FEATURES

– ON/OFF Power Button
– COB LED Work Light with 2 Settings
– SMD LED Focus Beam light
– USB Power Outlet (5V, 1.1A)
– State of Charge / Charging Status LED Indicator
– Dual Magnets on Rear of Unit
– Dual Mounting Hooks
– AC Wall Charger

CHARGING

NOTE: CHARGE THE WORK LIGHT IMMEDIATELY AFTER PURCHASE, AFTER EACH USE, AND AT LEAST EVERY 3 MONTHS WHEN NOT IN USE. Failure to do this will reduce the battery’s useful life.
Connect the pin jack end of the charging cable to the pin jack port on the work light. Connect the USB end of the charging cable to the USB port of the AC charger. Plug the AC charger into a functioning AC outlet.
The blue state of charge / charging status LEDs will blink in succession to indicate charging progress. To reach full charge, continue charging until all four LEDs are lit solid.
Charging will take approximately 4 hours, depending on the unit’s state of charge at the start of the cycle.
The charging process is fully automatic and the light can remain connected to the charger indefinitely without adverse consequences.

OPERATING INSTRUCTIONS

Do not turn on the work light while it is being charged.
Direct the lens away from your eyes before turning on the work light.
Press the POWER button to achieve the operational mode desired:
– Press POWER for COB Work Light low brightness mode.
– Press POWER a second time for COB Work Light high brightness mode.
– Press POWER a third time for Focus Beam Light mode.
– Press POWER a fourth time to turn the unit OFF.
NOTE: All light operating modes are adjustable. When in any light operating mode, hold down the power button.
The light will flash twice and begin to dim until it reaches the lowest setting and then begin to increase again.
The unit incorporates a rotating arm with an integrated magnet in its base for ideal positioning, allowing it to be attached to any ferrous metal surface. In addition, the unit has dual magnets and hooks for mounting on the rear of the unit.
Recharge the work light after use, and at least every 3 months when not is use.

MAINTENANCE INSTRUCTIONS

After use and before performing maintenance, disconnect the work light from the charger.
Use a dry cloth to wipe any dirt or oil from the charger, cord and light.
Any servicing should be performed by qualified service personnel.

STORAGE INSTRUCTIONS

Store inside, in a cool, dry place.
Take care to avoid/prevent damage to the charger, cord and unit. Failure to do so could result in personal injury or property damage.
Charge the work light’s internal battery immediately after purchase, after use and every 3 months when not in use.
All batteries are affected by temperature. The ideal storage temperature is 70˚F. The internal battery will gradually self-discharge (lose power) over time, especially in warm environments. Leaving the battery in a discharged state may result in shorter than expected battery life.

REPLACEMENT PARTS

Charger replacement kit (includes wall charger and USB/pin jack) – PART NO. LNC217

LIMITED WARRANTY

Clore Automotive warrants this product to be free from defects in material or workmanship for a period of one year from the date of original end user purchase.
This warranty extends to each person who acquires lawful ownership within one year of the original retail purchase, but is void if the product has been abused, altered, misused or improperly packaged and damaged when returned for repair.
This warranty applies to the product only and does not apply to any accessory items included with the product, which are subject to wear from usage. Accessories include, but are not limited to, wall chargers, charging cables and hooks. The replacement or repair of these items shall be at the expense of the owner.
THE TERMS OF THE CLORE AUTOMOTIVE LIMITED WARRANTY CONSTITUTE THE BUYER’S SOLE AND EXCLUSIVE REMEDY. IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED IN DURATION TO THIS EXPRESS WARRANTY. AFTER 1 YEAR FROM DATE OF PURCHASE, ALL RISK OF LOSS FROM WHATEVER REASON SHALL BE PUT UPON THE PURCHASER.
CLORE AUTOMOTIVE SHALL NOT BE LIABLE FOR INCIDENTAL AND CONSEQUENTIAL DAMAGES UNDER ANY CIRCUMSTANCES: CLORE AUTOMOTIVE’S LIABILITY, IF ANY, SHALL NEVER EXCEED THE PURCHASE PRICE OF THIS PRODUCT REGARDLESS OF WHETHER LIABILITY IS PREDICATED UPON BREACH OF WARRANTY (EXPRESS OR IMPLIED), NEGLIGENCE, STRICT TORT OR ANY OTHER THEORY.
Some states do not permit the limitation of warranties or limitation of consequential or incidental damages, so the above disclaimer and limitation may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
Instructions for obtaining service under this warranty:
If this product fails within the warranty period due to a defect in material or workmanship, return it to your place of purchase for an exchange.
Registering Your Purchase
For best service and to receive periodic product updates, please visit www.cloreregistration.com, click on the Light-N-Carry logo, choose your model number, complete the information in the web form and click “submit.”
It’s that easy!
For answers to questions concerning use, out-of-warranty service, or warranty/service information on this or other Clore Automotive products, contact: Clore Automotive Technical Service
800.328.2921
913.310.1050
www.cloreautomotive.com