COSTWAY NP10203 Large Nest Swing with Adjustable Hanging Ropes for Backyard User Manual
- June 4, 2024
- COSTWAY
Table of Contents
COSTWAY NP10203 Large Nest Swing with Adjustable Hanging Ropes for
Backyard
With your inspiring rating, COSTWAY will be more consistent to offer you EASY SHOPPING EXPERIENCE, GOOD PRODUCTS, and EFFICIENT SERVICE!
THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP IT FOR FUTURE REFERENCE.
IMPORTANT
READ AND FOLLOW ALL SAFETY INFORMATION AND INSTRUCTIONS, KEEP FOR FUTURE
REFERENCE
WARNING! CHOKING HAZARD-SMALL PARTS, NOT FOR CHILDREN UNDER 3 YEARS.
WARNING! DO NOT USE WITHOUT ADULT SUPERVISION! WARNING! ADULT ASSEMBLY IS REQUIRED!
ESSENTIAL INFORMATION
- Recommended for children 3+ years
- Do not leave child unattended while in use
- CAUTION: Use only under adult supervision
- Good safety practices should be followed at all times
- Read all instruction before using this product.
Intended solely for family and domestic use, not for a commercial playground or daycare. Two adults are needed for assembly. Hanging hardware not included. Ideally, the swing body should be hung over grass, sand, wood chips, or other soft surfaces. Under no circumstances should it be hung over concrete, asphalt, or other hard surfaces. Distance from the ground should not exceed 40cm; the maximum fall height should not be more than 46cm, Two S hooks are attached to the rope to allow for adjustment of the rope length. Please be sure to examine the ropes regularly to check for wear. The rope will, in time, degrade. If the color of the rope has become pale, frays easily, or gives off a powdery material when rubbed between the fingers, we recommend you replace the rope. Equipment should be hung in such a way that a distance of at least 2m is clear on either side. Can be hung on an A-frame swing set or on a tree limb of a diameter of at least 25cm.
WARNING!
Small parts for assembly by an adult.
- Tools Required (included in the packaging)
Swing Assembling
- Swing includes 4 PCS tubes, and 2 hanging ropes, a swing body for assembly.
- Insert LPC “U” shaped tube with foam into the sleeve first, and put the other one aside.
- Insert the 2 CURVED tubes into the sleeve.
- Connect two tubes by inserting the small socket into the big socket.
- Insert the last “U” tube into the sleeve, as shown.
- Connect the “U” shaped tube to the curved tubes.
- Insert the screw bolt into the holes of the frame, and make sure the holes are aligned.
- Fix it with a washer and nut.
- Use a wrench to tighten it.
- The assembled rope is shown.
- Assembly finished, adjust the rope length, and ready to swing now.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>