EBECO 170621 Clear Mirror Instruction Manual
- June 12, 2024
- EBECO
Table of Contents
Manual Clear Mirror
Before installation:
- If the mirror is housed in a metal frame, the frame must be earthed.
- Ebeco Clear Mirror should not be cut.
- Never leave anything across the mirror surface – overheating could occur.
- The mirror must be out of reach of the bath or shower.
Installation Ebeco Clear Mirror
- Carefully mark the back of the mirror where the heater is to be positioned.
- If the mirror is mounted flush to the wall cut out a recess in wall for the terminal cover.
- Peel back the protective release paper from one edge of the mirror heater. Position this edge in the marked area and peel back the release paper whilst gently applying pressure to remove any air bubbles.
- Ebeco Clear Mirror can be connected to the lighting circuit or to the electrical circuit through a separate switch. The circuit must however be protected by a 30mA circuit breaker.
The installation must be in accordance with existing regulations.
EBECO AB, Lärjeågatan 11,
SE-415 25 Göteborg, Sweden,
+46 (0)31-707 75 50,
info@ebeco.se,
www.ebeco.com
Clear Mirror, 170621
Documents / Resources
|
EBECO 170621 Clear
Mirror
[pdf] Instruction Manual
170621 Clear Mirror, 170621, Clear Mirror, Mirror
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>