Shiftall Dongle One User Manual

Shiftall Dongle One User Manual

Setup Guide

• STEP 1
  Download and install the drivers for this product (Shiftall dongle One) and the devices tobeconnected to the PC to be used.

• STEP 2
  Connect this product to the USB terminal of the computer while the computer is turnedon.

• STEP 3
  Pair the device to be connected to this product. For pairing instructions, please refer to the manual of the device to be connected.

Before You Begin

Introduction

Thank you for your purchase of the Shiftall dongle One. Please read this document before use. After reading,

please keep it in a safe place. Refer to this document for important information on safe use.

Included Items

Disclaimer and Regulatory Information

Usage

• Use and storage location
  • Do not leave the product in direct sunlight or a high-temperature place such as in front of a heater.
  • Do not place the product in a dusty area.
  • Do not place the product in a place subject to high vibration.
  • Do not use or place in a humid area such as a bathroom.
• Regarding handling
  • Do not drop, step on, or hit the product, as it may cause malfunction.
  • Do not wash with detergent or a cleaning agent.

Care and Maintenance

• If the unit is very dirty, first wipe off the dirt with a slightly damp cloth, thenwipewithadry cloth.
• Do not allow contact with solvents such as paint thinner, alcohol, benzine, kitchenorcloth detergent. Exposure to chemicals may change the quality of the unit or causethepaint to peel off.

Disposal

Dispose of this product according to local environmental regulations. Do not disposeof it alongwith normal household waste.

Copyright, etc

• Other names, company names and product names mentioned in the text are trade marks or registered trademarks of their respective owners.
• Authentication information can be found on the sticker located on the backof the main unit.

Contact Information

For other inquiries, please contact the Shiftall Support Desk.

Shiftall Support Contact Email Address
https://en.shiftall.net/support

FCC CAUTION

Any Changes or modifications not expressly approved by the party responsible for compliance could voidtheuser’sauthority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant topart15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interferenceinaresidential installation. This equipment generates uses and can radiate radio frequency energy and, if not installedandused in accordance with the instructions, may cause harmful interference to radio communications. However, thereisno guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off andon, theuserisencouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and receiver
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help

The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

All other devices shall bear the following statement in a conspicuous location on the device:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. When the device is so small or for such use that it is impracticable to label it with the statement specified under paragraph (a) of this section in a font that is four-point or larger, and the device does not have a display that canshowelectronic labeling, then the information required by this paragraph shall be placed in the user manual andmustalsoeither be placed on the device packaging or on a removable label attached to the device.

All company names, system names, and product names mentioned in this manual, with the exception of Shiftall andShiftall dongle One, are registered trademarks or trademarks of their respective companies, and are not thepropertyofour company.
In principle, “TM” and “®” are omitted in the text and figures.

References

• Support - Shiftall Inc.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>