RHINO-RACK 667863 Rhino Anchor Straps Instruction Manual
- June 12, 2024
- RHINO RACK
Table of Contents
Rhino Anchor Straps (RAS)
667863 Rhino Anchor Straps
Important:| Please read these instructions carefully prior to
installation.
---|---
Please refer to your fitting instruction to ensure that the bike rack is
installed in the correct locations.
Check the contents of kit before commencing fitment and report any
discrepancies.
Place these instructions in the vehicle’s glove box after installation is
complete.
Layout
This product is designed to aid in the safety of transporting long items (i.e. Kayaks) and not to be used for towing or pulling applications. Special consideration must be taken when selecting your fixing point. RhinoRack Pty Ltd does not take any responsibility for damage to the vehicle that may be caused by this product on paintwork, panels and fixing hardware. Although they are designed with the softest materials in mind to minimise this damage, they cannot take into consideration the variation of panel gaps and wind flapping issues. It is the users responsibility to ensure that the strap is used in accordance with these fitting instructions.
Parts List
| Item | Component Name | Qty | Part No |
|---|---|---|---|
| 1 | Anchor Strap | 2 | RAS |
| 2 | M10 Flat Washer | 2 | |
| 3 | Fitting Instruction | 1 | R224 |
Care Instruction : Wash and clean vehicle roof racks prior to fitment
Warning:
It is important that all roof racks and accessories are installed and attached
correctly. Failure to follow the correct attachments could result in an
accident, serious injury or death to others. The driver of the vehicle is
responsible for securing the roof racks and accessories, checking the
attachments, periodically checking bolt torque and visual inspection of all
components for wear and damage. Do not attempt to fit the roof rack system or
accessory to your vehicle unless you fully understand these fitting
instructions. Please direct any questions regarding fitting to the dealer or
retailer from where they were purchased.
Use only non-stretch fastening ropes or straps.
Note for Dealers and
Fitters
It is your responsibility to ensure this fitting instruction is given to the
end user or client
Important Information
Rhino-Rack
3 Pike Street, Rydalmere,
NSW 2116, Australia.
(Ph) (02) 9638 4744 (Fax) (02) 9638 4822| Document No: R224
Prepared By: Andy Wana
Authorised By: Chris Murty| Issue No: 01
Issue Date: 26/07/2012
---|---|---
These instructions remain the property of Rhino-Rack Australia Pty Ltd and may
not be used or changed for any other purpose than intended.
WARNING! Important Load Carrying Instructions
With utility vehicles, the cabin and the canopy move independently. Roofracks
and vehicle can be damaged if the item transported is rigidly fixed at points
on both the cabin and canopy. Instead, rigidly fix to either the cabin
roofracks or the canopy roofracks.
Fitting instructions for use with Pioneer Tray
-
Open bonnet and locate bolt
Locate a bolt just back from the headlights. This bolt should not be attached to any plastic parts such as brackets for headlights, but instead only there for metal to metal securing purposes.
-
Remove bolt
Use a socket wrench to remove bolt
-
Install anchor straps
Install the anchor strap and washer as shown.
Repeat for the second anchor strap at the other side of the vehicle.
-
Tie your load to the anchor straps
Loop your tie down straps through the anchor straps as shown. Use of metal hooks is discourages as they may damage your vehicle.
-
When not in use, fold straps over and hide them under the bonnet of the car. Avoid the straps flapping as they may cause paintwork damage.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>