InCarTec 39-PGA-PDC Citroen and Peugeot CAN steering and PDC interface Instruction Manual
- June 12, 2024
- InCarTec
Table of Contents
39-PGA-PDC Citroen and Peugeot CAN steering and PDC interface
39-PGA-PDC Citroen and Peugeot CAN steering and PDC interface
CANbus steering wheel control and PDC retention interface for Citroen and
Peugeot cars.
The CANbus interface also generates CAN ignition and speed pulse,
illumination, parking brake and reverse gear signal outputs.
Set up the patch lead
Pioneer and Sony
Pin 1 black (base)
Pin 2 red (middle)
Pin 3 not connected
Pin 4 white (tip) Alpine, Clarion and JVC
Pin 1 black (base)
Pin 2 white (tip)
Pin 3 not connected
Pin 4 red (middle) JVC, Kenwood and Zenec
Pin 1 not connected
Pin 2 blue (single wire)
Pin 3 not connected
Pin 4 not connected Chinese/Learning (Use blue single wires)
Pin 1 (SWC/KEY Ground)
Pin 2 not connected
Pin 3 not connected
Pin 4 blue (SWC/KEY1)
The 4 pin patch lead connector diagrams above are viewed from the wire entry
side of the connector.
Set the switches
The switches on the interface need to be set according to the brand of radio
and vehicle model. Open the black box and set the switches.
See the tables below for the switch settings. Switches 1-4 relate to the brand
of head unit and switched 5-8 relate to the model of car.
| Switch | 1 | 2 | 3 | 4 |
|---|---|---|---|---|
| Alpine | Off | On | Off | Off |
| Kenwood | On | On | Off | Off |
| JVC | Off | Off | On | Off |
| Clarion | Off | On | On | Off |
| Zenec | Off | Off | Off | On |
| Sony | On | Off | On | On |
| Pioneer | Off | On | On | On |
| Chinese/learning | On | Off | Off | On |
| Switch | 5 | 6 | 7 | 8 |
| --- | --- | --- | --- | --- |
| All models, PDC retention on | Off | On | Off | Off |
Green—CAN active
Yellow– Ignition output active
When connected the green light will indicate that the interface is recognising
the vehicles CANbus, and the yellow light will indicate the interface is
giving out an ignition power supply.
If the green light is not on check the CANbus connections and switch settings.
Additional steering control functions
SRC + >> “Mode” button of original radio
SRC + << “Dark” button of original radio
+ << “Menu” button of original radio Push and hold for 3+ seconds
Menu button.
This will allow you to access the menu settings, the steering wheel buttons (Vol+, Vol-, << and >>) will now navigate the menus. SRC button will act as the OK button and >> + << together will act as the ESC button.
NOTE
The parking buzzer does not give an initial tone to signify that reverse gear has been selected.
Test the reversing tones by reversing the car towards an object, the reverse tones will not always sound if the ignition is on and the engine is not running.
Loose bullet connections:
Blue— Electric/Amplified antenna phantom power (where required)
Blue/White— amplifier turn on
Brown— Mute
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>