TUNDRA DRONE Automoving Light for dji Mavic 3 User Guide
- June 12, 2024
- TUNDRA DRONE
Table of Contents
TUNDRA DRONE Automoving Light for dji Mavic 3
Product Information
The product is called Automoving Light for DJI Mavic 3 Tundra Drone. It is a light unit that can be attached to the aircraft’s camera. The product is manufactured by Tundra Drone AS and designed in Norway. The company’s address is Bredbuktnesveien 2, 9522 Kautokeino, Norway.
Product Usage Instructions
1. Mount the green tracking mark sticker aligned to the circle on the aircraft’s camera. 2. Mount the red tracking sticker on the aircraft’s camera (refer to the illustration). 3. Position the Automoving light unit below the aircraft. 4. Insert the aircraft from above into the Automoving light’s inner body, ensuring there is no gap. 5. Adjust the horizontal position of the light according to your requirements. 6. For optimal performance, position the light horizontally to point straight down. For more detailed instructions, please refer to the User Manual.
INSTALLATION
- Mount the green tracking mark sticker aligned to the circle on the aircraft’s camera. Mount the red tracking sticker on the aircraft’s camera (see illustration).
- Position the Automoving light unit below the aircraft. Insert the aircraft from above into the Automotive light’s inner body.
- Place the Automoving light Battery into the Automoving light’s battery slots’ starting point. Press in the «Battery Latches» on both sides of the battery and slide the battery. Make sure the battery is mounted securely and that the «Battery Latches» have clicked into place on both sides.
- When correctly mounted, there should be no «GAP» between the battery and the battery connector on the Automoving light unit. Hold the power button on the battery down for around 3 seconds to turn on the Automoving light. On startup the floodlight LED will blink once, when the boot sequence is ready the lamp will blink one more time.
- Set the function of the customizable «C2 button» in the DJI Controller to turn on/off the «Recenter/Tilt down gimbal». The light is toggled when the camera goes from horizontal to straight down and back to horizontal within 2 seconds, this is done by clicking the C2 button two times within 2 seconds.
- Power up the aircraft and make sure that the DJI Fly app connects to the aircraft. Tilt the «Drone Camera» by pressing the «C2 button» horizontally to straight down and back within 2 seconds with the DJI Remote controller (the flood light will turn «ON/OFF» after the Automoving light is mounted to the drone successfully).
Find the detailed User Manual
Manufactured by Tundra Drone AS
- Address: Bredbuktnesveien 2,
- 9522 Kautokeino, Norway
- Designed in Norway