Tundra Drone AS Mavic 2 Automoving Light Installation Guide

AS Mavic 2 Autoboxing Light

Installation Guide

INSTALLATION

Mount the green tracking mark sticker aligned to the circle on the aircraft’s camera. Mount the red tracking sticker on the aircraft’s camera (see illustration).

Slide the Automating light unit above the belly of the aircraft above the rear aircraft arm while maintaining a 45° angle. As you do this, begin to adjust the Autoboxing light unit’s angle so that, after the end of the sliding motion, it is parallel to the aircraft’s body.

Insert the Autoboxing light Battery into the Automating light’s battery slots.
Slide the battery forwards to the Automating light’s battery compartment.

Make sure the battery is mounted securely and that the battery latches have clicked into place. The image illustrates a correctly mounted battery. There should be no «GAP» between the battery and the battery connector on the Automating light unit.

Slide the cable plug upwards until it reaches the front LED. Slide it upwards until it fully covers the aircraft’s front LED. Fasten the cable below the drone’s arm with the Velcro.
Connect the USB C connector to the USB C port on the Automating Light.

Hold the power button on the battery down for around 3 seconds to turn on the Automating light. On startup the floodlight LED will blink once, when the boot sequence is ready the lamp will blink one more time.

https://tundradrone.com/support
Scan me for User Manual
Find the detailed User Manual:
https://tundradrone.com/support
Address: Suomaluodda 44,
9520 Kautokeino, Norway
Designed in Norway
Manufactured by Tundra Drone AS

Documents / Resources

| Tundra Drone AS Mavic 2 Automoving Light [pdf] Installation Guide
Mavic 2 Automoving Light, Mavic 2, Automoving Light, Light
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>