InCartec 29-CTF05 Ford Steering Wheel Control Interface Instruction Manual

InCartec 29-CTF05 Ford Steering Wheel Control Interface

Key Features

• Retains Steering Wheel Controls (if equipped)
• Retains Menu Control Via SWC
• Provides Speed Pulse, Park Brake, Reverse Gear & Illumination

The information provided in this document is subject to change without notice due to changes and/or improvements to the product/s.

Features

Vehicle Application
Ford Fiesta (JA8) 2010 – 2012
For Vehicles with Red Display Only & ‘OK’ Button on Steering Wheel

ABOUT THIS PRODUCT

CAN-Bus Steering Wheel Control Interface for Ford vehicles with red display, OK button on the steering wheel, Visteon original stereo and 24 Way connector.

WIRING COLOUR CODES

Purple                 Right Rear Speaker +
Purple/Black    Right Rear Speaker –
Green                 Left Rear Speaker +
Green/Black     Left Rear Speaker –
Grey                   Right Front Speaker +
Grey/Black        Right Front Speaker –
White                 Left Front Speaker +
White/Black     Left Front Speaker –
Yellow               Permanent 12V
Black                 Ground
Red                    Ignition 12V
Orange              Illumination
Pink                  Speed Pulse
Green               Park Brake
Purple/White   Reverse

PRIOR TO INSTALLATION

Read the manual prior to installation. Technical knowledge is necessary for installation. The place of installation must be free of moisture and away from heat sources. Please ensure that the correct tools are using during the installation to avoid damage to the vehicle or product.

FITTING GUIDE

1. Remove and disconnect the original head unit.

2. Connect the 12 way Molex connector of the head unit patch lead (supplied separately) to the interface.

3. Connect the opposite end of head unit patch lead to the head unit steering wheel control input on the back of the aftermarket head unit.
   NB: This may be a 3.5mm jack plug or a wire input depending upon the head unit brand being fitted. Please see the head unit installation manual for further information on where to connect.
   Important: This step must be completed before connecting power to the interface. Failure to so do may result in no steering wheel control function .
   

4. Connect the 14 way molex connector to the interface.
   

5. Connect the male power/speaker ISO harness to the female power/speaker ISO harness from the aftermarket head unit. For aftermarket head units without an ISO connector, please refer to “Wiring Colour Codes” on Pg. 2.
   

6. Connect the female vehicle specific connectors on the harness to the male vehicle connector from the vehicle.

7. Remove the car display connector from the vehicle and plug into the interface (please remove the dust cover from the interface before making the connection).

8. Connect the display connector from the loom to the vehicle (the port previously occupied by the car display connector, removed in Step 7.)

Test head unit for correct operation.

STEERING WHEEL CONTROL FUNCTIONALITY

Original Button             Function
Volume +                            Volume +
Volume –                            Volume –
Right Arrow                      Track +
Left Arrow                        Track –

ACCESSING THE MENU

1. To enter Menu Mode, hold the ‘OK’ button down for 3 seconds
2. To navigate the menu, use the Volume +/Volume – and Track +/Track – buttons. Push the ‘OK’ button to select an option.
3. Menu Mode will be automatically exited after 10 seconds without a button press.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>