Pioneer TS-W3020PRO PRO Series 12 DVC Car Subwoofer Owner’s Manual
- June 12, 2024
- Pioneer
Table of Contents
Pioneer TS-W3020PRO PRO Series 12 DVC Car Subwoofer
Thank you for purchasing this Pioneer product. Be sure to read this instruction manual before installing this speaker.
Safety Instruction
WARNING
The sealed enclosure series subwoofers are capable of reproducing music at
extremely loud levels. Caution should be exercised to prevent permanent
hearing loss. Additionally, driving with the system at high volume levels
could impair your ability to hear emergency vehicles.
CAUTION
- To prevent damage to your speakers please observe the following caution.
- At high volume levels if the music sounds distorted or additional sounds are perceived lower the volume.
- PIONEER recommends that this speaker be used in conjunction with amplifiers whose continuous (RMS) output is lower than the nominal input power of this speaker.
- Since this speaker is continuously used being turned on full blast, the temperature of the magnetic circuit rises, avoid touching it directly by hand and placing something near it. If it is heated, it may cause a burn, deformation of or damage to peripheral things.
- Never connect only one voice coil of this Dual Voice Coil (DVC) speaker.
- Both voice coils must be connected to the amplifier for correct operation.
- If this product is used in free-air conditions (without an enclosure), insufficient damping causes the sound without accuracy and reduces the power handling capability to 1/4 of its usual levels. It may resuit in permanent damage to the product.
FEATURES
- Super wide urethane surround & stitch combined structure realize high durability under high power input
- Double-stacked large magnet & 4-layer long voice coil with an aluminum bobbin to produce louder bass and realize high heat-dispersion effectively
- Aluminum die-cast basket design to sustain accurate and large cone motion (TS-W3820PRO / TS-W3020PRO)
- Thick steel basket design to sustain accurate and large cone motion (TS-W3010PRO)
DVC (DUAL VOICE COIL) CONNECTION
Connection
- 2 Ω Bridged mono (Parallel)
- 1 Ω or 4 Ω Stereo
- 1 Ω or 4 Ω Bridged mono
Speaker wiring
- 4 Ω Wiring
- 1 Ω or 4 Ω Wiring
- 1 Ω or 4 Ω Wiring
Advantage
- Good for higher sensitivity
- Good for higher sensitivity
- Good for channel separation
- Good for higher sensitivity
Notice: Verify that your amplifier can operate in a 1 Ω or 4 Ω mono configuration.
CAUTION:
Never connect only one voice coil of this Dual Voice Coil (DVC) speaker. Both
voice coils must be connected to the amplifier for correct operation.
SPECIFICATIONS
How To Install
PARTS INCLUDED
Information Note for Customers in CIS countries.
TEMPLATE
PIONEER CORPORATION 2022
- 28-8, Honkomagome 2-chrome, Bunkyo-ku, Tokyo 113-0021, JAPAN / JAPON
- PIONEER EUROPE NV Haven 1087, Keetberglaan 1, B-9120 Melsele, Belgium / Belgique
- PRINTED IN CHINA IMPRIME EN CHINE <860-E121253-01-01)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>