SEALEY HT111R Rechargeable Head Torch Instruction Manual
- June 13, 2024
- SEALEY
Table of Contents
5W COB LED RECHARGEABLE HEAD TORCH
WITH AUTO SENSOR
MODEL NO: HT111R
Thank you for purchasing a Sealey product. Manufactured to a high standard,
this product will, if used according to these instructions, and properly
maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE
OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND
WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE
INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to instructions
SAFETY
1.1. GENERAL SAFETY
X DO NOT shine directly into your, another person’s or an animal’s eyes.
X DO NOT allow children to use the torch.
X DO NOT use the torch if you suspect that the battery or the torch casing is
damaged.
X DO NOT leave batteries in a discharged state. Before storage remove
batteries and dispose of in the correct manner.
1.2. BATTERY SAFETY
‰ WARNING! To reduce the risk of burns or fire:
X DO NOT attempt to open the batteries.
X DO NOT crush, puncture, short contacts or dispose of in fire or water.
X DO NOT expose to temperatures above 60°C (140°F).
Replace only with the batteries designed for this product.
Recycle or dispose of used batteries as stipulated by local regulation.
If the electrolyte in the batteries gets on your skin, thoroughly rinse with
water. If it gets in your eyes, rinse thoroughly with cool water and seek
immediate medical attention.
INTRODUCTION
Hands-free 5W COB LED spotlight with 40° angle adjustment. Dimmer switch allows brightness to be adjusted from 20% to 100%. Main light has one switch with 4-functions, on, flash, auto-sensor and off. Automatic sensor turns on and off when you move your hand in front. Rear of strap includes a red LED warning light which has 2-functions, flash or on, ideal for a cycling light. Adjustable headband and foam brow for added comfort. Includes a battery charging level indicator. Powered by rechargeable 3.7V 2.2Ah lithium-ion battery. Supplied with micro USB charging lead.
SPECIFICATION
MODEL NO: …………………………………………………….HT111R
Battery: ……………………………………………….3.7V 2.2Ah Li-ion
Charging Time: ………………………………………………………3.5hr
LED Type: ………………………………………………………. 5W COB
Lumen Output: ………………………….. High; 450lm, Low; 110lm
Nett Weight: …………………………………………………………. 225g
Operating Time: …………………………… High; 2.5hr, Low; 8.5hr
OPERATION
4.1. TORCH OPERATION
4.1.1. Press power button (fig.1) once to turn light on.
4.1.2. Press the power button twice (fig.1) to put it into flash
4.2. LIGHT SENSOR
4.2.1. Press power button for three seconds until infra red led illuminates.
4.2.2. Pass hand in-front of light until light comes on.
4.3. RED LIGHT ON POWER PACK
4.3.1. Press power button on power pack (fig.2) once for solid red light.
4.3.2. Press twice for flashing red light.
MAINTENANCE
5.1. CHARGING: Connect the USB lead to the port on the rear of the power
pack (fig.2) and a USB power socket. Turn on the power supply.
5.2. Keep the torch clean by wiping with a damp cloth.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools,
accessories and packaging should be sorted, taken to a recycling centre and
disposed of in a manner which is compatible with the environment. When the
product becomes completely unserviceable and requires disposal, drain any
fluids (if applicable) into approved containers and dispose of the product and
fluids according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the
EU Directive on Waste Electrical and Electronic Equipment (WEEE). When the
product is no longer required, it must be disposed of in an environmentally
protective way. Contact your local solid waste authority for recycling
information.
BATTERY REMOVAL
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd
are required to inform potential purchasers of products containing batteries
(as defined within these regulations), that they are registered with Valpak’s
registered compliance scheme. Jack Sealey Ltd Batteries Producer Registration
Number (BPRN) is BPRN00705.
Note: It is our policy to continually improve products and as such we
reserve the right to alter data, specifications and component parts without
prior notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is
required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk.
IP32 7AR
01284 757500
sales@sealey.co.uk
www.sealey.co.uk
© Jack Sealey Limited
Original Language Version
HT111R Issue 2 (2,3) 27/04/23
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>