SEALEY HT301R Rechargeable Head Torch Instruction Manual
- June 13, 2024
- SEALEY
Table of Contents
SEALEY HT301R Rechargeable Head Torch
Thank you!
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to instructions
SAFETY
✓ Inspect the cable and connector for wear and damage to ensure items are safe
before connecting to the power supply. If worn or damaged DO NOT use.
✓ Ensure the torch is fully charged before initial use.
✘ DO NOT charge in damp conditions.
✘ DO NOT turn the torch on when it is being charged.
✘ DO NOT shine directly into your, another person’s or an animal’s eyes.
✘ DO NOT allow children to use the torch.
✘ DO NOT handle or move the torch whilst it is being charged.
✘ DO NOT use the torch if you suspect that the battery or the torch
casing is damaged.
✘ DO NOT leave battery in a discharged state, recharge battery
immediately. Before storage, fully recharge the battery, subsequently recharge
the battery at least once every six months of non-use.
✘ DO NOT attempt to open, disassemble, modify or service the battery
pack.
✘ DO NOT crush, puncture, short external contacts or dispose of in fire
or water.
✓ Replace only with the battery pack designated for this product.
✓ Recycle or dispose of used battery as stipulated by local regulation.
✓ If the electrolyte in the cells gets on your skin, thoroughly rinse with
water. If it gets in your eyes, rinse thoroughly with cool water and seek
immediate medical attention.
INTRODUCTION
Hands-free 2.5W SMD LED head torch to direct light as required. Two power
settings – high and 60% power with an output of 250/150lm.
Green LED charge indicator. Extendable arms with foam pads for added comfort.
Supplied with Type-C USB charging cable.
SPECIFICATION
Model No :……………………………………………………….. HT301R
Battery: ………………………………………. 3.7V 1.6Ah Lithium-ion
Charging Time:………………………………………………………3.5hr
LED Type: …………………………………………………….2.5W SMD
Lumen Output: ………………………………..High/Low: 250/150lm
Operating Time: …………………………………… High/Low 2/3.5hr
OPERATION
Fit the torch to the head set using the washer, thumb-wheel, cover and screw.
Adjust the orientation of the torch to suit.
Pressing the power button once will turn the light on full power, pressing it
again will dim the light and pressing a third time will turn the light off.
CHARGING
NOTE: The torch can also be detached from the collar which may make
charging more convenient.
Remove USB socket cover on the torch.
Connect the USB lead to the port on the end of the battery pack and the other
end to a USB power socket. Turn on the power supply.
Switch off power supply, remove charging lead and replace socket cover on
battery pack.
The charge indicator (green LED) on the side of the torch will flash to show
the unit is charging and has charge.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools,
accessories and packaging should be sorted, taken to a recycling centre and
disposed of in a manner which is compatible with the environment. When the
product becomes completely unserviceable and requires disposal, drain any
fluids (if applicable) into approved containers and dispose of the product and
fluids according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the
EU Directive on Waste Electrical and Electronic Equipment (WEEE). When the
product is no longer required, it must be disposed of in an environmentally
protective way. Contact your local solid waste authority for recycling
information.
BATTERY REMOVAL
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd
are required to inform potential purchasers of products containing batteries
(as defined within these regulations), that they are registered with Valpak’s
registered compliance scheme. Jack Sealey Ltd Batteries Producer Registration
Number (BPRN) is BPRN00705.
Note: It is our policy to continually improve products and as such we
reserve the right to alter data, specifications and component parts without
prior notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is
required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
sales@sealey.co.uk
www.sealey.co.uk
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>