DALS Lighting GMB2-CC-XX 4 Inch Round Recessed LED Gimbal Light Instructions
- June 13, 2024
- dals Lighting
Table of Contents
Installation guide for
1 877 430 1818
www.dals.com
GMB2-XX
GMB4-XX
WET LOCATION AIR-TIGHT RATED
CERTIFIED
MODEL
| LUMENS| WATTS| COLOR TEMPERATURE| DIMMABLE
---|---|---|---|---
GMB2-CC-XX| 725 lm| 8W| 2700K, 3000K, 3500K, 4000K, 5000K |
GMB4-CC-XX
| 810lm| 11W | 2700K, 3000K, 3500K, 4000K, 5000K |
*Works with most dimmers. Refer to DALS website for dimmer compatibility list.
ITEMS INCLUDED IN THE BOX
A: Rotation 360°
B: Tilt 30°
(1) 1x LED gimbal light with CCT switch
(2) 1x Junction box with integrated driver
SIDE VIEW OF INSTALLATION
- Color Select
- Beam angle: 40°
WARRANTY
DALS offers a warranty of 5 years from the date of purchase that covers repair or replacement of defective parts of the housing, optics, and electronics. To contact DALS customer service call to 1-877-430-1818 or send an e-mail to info@dals.com.
BEFORE YOU START
BEFORE STARTING INSTALLATION, SHUT THE LINE FEED POWER OFF USING THE
CIRCUIT BREAKER.
Instructions pertaining to a risk of fire, electric shock or injury to
persons. Installation must be done according to local electrical codes.
Installation should be done by a certified electrician.
This class B digital apparatus complies with Canadian ICES-005. This digital
apparatus does not exceed the Class B limits for radio-noise emissions from
digital apparatus as set out in the Radio Interference Regulations of the
Canadian Department of Communications.
INSTALLATION INSTRUCTIONS
(1) Drill hole in ceiling and prepare supply wires. Install and unshield the line feed wire 6″ (15 cm) and strip wires 5/8″ (1.6 cm). Bring supply power to junction box through knockout.
GMB2-CC-XX
Ø2-1/4″
GMB4-CC-XX
Ø4-1/4
(2) Open the lid of the junction box. Use the quick connectors to pair the wires from the main line to the wires from the junction box.
GMB2-CC-XX
Maximum of 3, #12 conductors in the junction box.
GMB4-CC-XX
Maximum of 6, #12 conductors in the junction box.
(3) Route junction box through cut-out and connect recessed LED pannel to junction box with the quick connector.
Don’t forget to select the color temperature you would like.
(4) Compress the springs and push the fixture in the opening. It is easier to do one spring at a time.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>