Green Cell 24V Power Inverter User Guide

: June 13, 2024
: Green Cell

Table of Contents

Instruction
USER GUIDE
SAFETY RULES
GENERAL WARRANTY CONDITIONS
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

Green Cell 24V Power Inverter User Guide

Instruction

Connection Instruction

AC outlet.
LED indicator: Power (green), Failure (red).
ON/OFF switch.
USB port.
Fan.
Direct current connection input (Red+, Black-).
Cigarettes lighter cable (150 W for 12 V and 300 W for 24 V MAX).
Connecting cables.
Grounding connection

1 2V inverter connection
24V inverter connection
Output connection

Note: 12 V and 24 V inverters are connected in similar ways, the only difference is that the 24 V batteries are connected in series.

USER GUIDE

In order to ensure that your new power inverter will work properly, pro-vide long operation time and lifespan, follow the instructions below.

SAFETY RULES

Caution is required while using and disposing of the device. Incorrect usage and not following the guidelines below may pose a threat to life or health and property.

Do not throw into fire.
Do not use the inverter near flammable objects.
Keep away from extreme heat, cold, and moisture.
Do not expose the inverter to temperatures exceeding 40 °C (104 °F).
Do not spray with water under high pressure.
Place the device in a clean environment.
The inverter case may become very hot under high power operation. Ensure at least 5 cm (2 in) of air space on all sides of the device.
Keep out of reach of children and pets.
Do not bite, suck, crush, or pierce, do not open the case and do not drop.
Do not insert any objects into the AC outlet, fan or vent openings.
Do not open the device. Do not try to repair it on your own.
The inverter generates the same potentially lethal AC power as a normal wall socket, handle with caution. • Use the supplied power cables to connect the inverter with the bat-trey. If 2 pairs are included, connect both in parallel. Otherwise, a cable may become hot and eventually cause sparks or fire.
The inverter has two terminals installed in the case, connect them with the battery or cigarette lighter socket using supplied wires
Do not connect devices with required power greater than the inverter power. When using the inverter continuously, we rec-omens using 85% of the maximum power to extend the life of the device.
Sparks may occur when connecting the unit to the battery, which is normal. Before connecting, make sure that there are no flammable fumes or materials nearby
Do not use the inverter with battery operated devices or chargers for power tools that have dangerous voltages on the terminals.
Do not use the inverter with medical equipment
If you see any damage, do not use the device.
Be careful when handling and disposing of the device. Incorrect use of the inverter may cause health and safety

hazards.
Note: A reverse polarity connection (positive to negative) may dam-age the inverter fuse. Damage caused by a reverse polarity connec-tion will invalidate your warranty.
At the end of its useful life, do not dispose of the device with your normal household waste. For proper treatment, recovery and reedy-cling, take this product to a designated collection point.

Connecting devices

Before connecting a receiving device, connect the inverter to a bat-tery or a cigarette lighter using appropriate wires.
Verify the battery voltage and make sure the inverter is properly selected for it.
To connect the inverter to the battery, connect the red terminal (+) with the battery positive (+) sign using the red cable. Then, connect the black terminal (-) with the negative (-) mark of the battery with the black cable.
To connect your inverter to the cigarette lighter socket, select the appropriate cable and connect in the same way: black cable with black terminal and red cable with red terminal.
Tighten the cap on each DC terminal. If the design of the connector is suitable, use tools to tighten the screw.
Plug the device into the mains or USB port on the inverter casing.

Note: When connecting a device with your inverter through the ciga-rette lighter cable, use devices with maximum 150 W power for 12 V and maximum 300 W for 24 V sockets. If these values are exceeded, the cigarette lighter socket may be damaged or the fuses in the sock-et installation may blow.
Using the inverter
Note: Before using the inverter, provide a ground connection wire (choose a heavy duty, insulated wire). Use the terminal on the back of the inverter to connect to a grounded power outlet. If you are using a vehicle battery, mount the cable on the chassis. If you are using a boat battery, mount it on its grounding system.

Turn the inverter ON by switching the button from 0 to 1.
When the green LED lights up, you can start the connected device. If there is more than one device connected, start them one by one, in short time spaces.
After using the inverter, disconnect it from the power supply.

Note: We recommend using batteries designed for cyclic operation. If a „low battery voltage” alarm sound turns on, switch the inverter off immediately. When the battery is fully charged, the inverter can be used again. If the inverter is used with a vehicle, you must start the engine every time to use the inverter.

Replacing the fus e
To properly replace a fuse in your inverter, follow the instructions below: 1.

Disconnect your inverter from a power source, turn it on, and let it discharge completely (the indicator lights should turn off). 2. Remove 4 screws from the inverter cover and remove the cover.
Remove the fuses from the slots on the motherboard by pulling them upward.
Insert new fuses.
Place the cover and screw in the 4 screws.
Start the unit with extra caution.

Note: The INVGC series usually have more parts that need to be detached and may have fuses situated on the device casing. If the fuses are inside the device, you have to unscrew the front and back panel first and then the bottom panel to access them. Then, to re-place fuses in your INVGC models, follow the instructions listed in “Replacing the fuse” in steps 3-6.

All pictures shown are for illustration purpose only and may be different from the actual product. For more information, contact our customer service center.

The WEEE symbol means that according to local laws and regulations your product and its battery(is) should be disposed of separately from household waste. When this product reaches its end of life, take it to a collection point designated by local authorities for safe disposal or recycling. The separate collection and recycling of your product, its electrical accessories, and its battery will help conserve natural resources, protect human health, and help the environment.
This product is in compliance with Directive 2011/65/EU of the Euro-pecan Parliament and of the Council of 8 June 2011, on the restriction of the use of certain hazardous substances in electrical and electronic equipment (RoHS) and its amendments.

GENERAL WARRANTY CONDITIONS

CSG S.A., with its seat in Cracow 3, 30-509 Krakow, Poland), hereinafter referred to as the Guarantor, guarantees proper and failure-free operation of the product throughout the war-rant period.
The warranty period shall last for 24 months and is calculated from the date of delivering the product to the Purchaser.
3. Territorial scope of warranty protection covers the European Union, countries of the European Economic Area, the United King-dome, Russia, Ukraine, Turkey and Albania.
The warranty does not exclude, limit or suspend the rights of the Purchaser resulting from the implied warranty for defects.
In order to benefit from the warranty, contact the seller via e-mail:
In order to benefit from the warranty, contact the seller via e-mail: support@greencell.global. The handling of the complaint will be ac-celerated by a completed complaint form available at: Greenwell. global.
The Guarantor will inform the Purchaser about the method of processing the warranty complaint (i.e., acceptance or refusal of ac-ceptance) within 14 days from the receipt of the product. In case the Guarantor acknowledges the validity of the complaint, the defect of the product will be removed by the Guarantor or the defective prod-uct will be replaced with one without defects within 14 days from the date of informing the Purchaser of the validity of the complaint. The Guarantor decides how the complaint will be handled, taking into account the Purchaser’s request in the complaint form, if possible. If removal of defects due to the degree of difficulty requires a large amount of work or additional measures, this period may be extend-ed, but the Guarantor will make every effort to repair the product as soon as possible. 7. In the case of acknowledging the validity of the complaint, the Guarantor covers the cost of delivery of the defective product to the Guarantor service and the cost of delivery of the repaired or replaced product to the Purchaser.
The Guarantor’s liability covers only defects resulting from causes inherent in the product.
The warranty does not cover a product:
- with broken warranty seal;
- damaged by external factors (damage caused by lightning, surges in low voltage installation and power supply network, flooding, fire, intentional mechanical and thermal damage, etc.);
- damaged due to improper use or use inconsistent with the manual;
- damaged due to improper connection of other peripheral devices;
- with traces of unauthorized repairs, unauthorized modifications or design changes.

For more information about using, installation and maintenance of the Power Inverter, visit our website greencell.global.com

© ® Green Cell Fresh Energy. Registered trademark. All rights reserved. Actual product may differ from pictures. All brand names and products are registered trademarks of their respective owners.
Warranty service:
Green Cell ul.
rtm. Witolda Pileckiego 8 32-050 Skawina, Poland tel. +48 12 444 62 47
Manufactured for: CSG S.A. ul. Kalwaryjska 33 30-509 Krakow, Poland

Support
Points de collect sur www quefairedemesdechets.fr Privileges’ la reparation outlet don de voter apparel !
Icons
Made in China